P/No. MFL32049830 P/No.
Table of contents Introduction Installation Operation Suggestion on food storage Care and maintenance 2 Entry 3 Important safety instruction 3 Identification of parts 4 Where to install 5 Door removal 6 Door replacement 7 Water supply installation 7 Height adjustment 8 Setup 9 Adjusting the temperatures and functions 9 Refreshment center (Applicable to some models only) 15 Shelf (Applicable to some models only) 16 Wine holder (Applicable to some models only) 16 Egg box (Appli
Introduction Entry The model and serial numbers are found on the inner case or back of refrigerator compartment of this unit. These numbers are unique to this unit and not available to others. You should record requested information here and retain this guide as a permanent record of your purchase. Staple your receipt here.
Introduction Child entrapment warning DANGER: Risk of child entrapment. Before you throw away your old refrigerator or freezer take off the doors but leave the shelves in place so that children may not easily climb inside. The appliance is not intended for use by young children without supervision. Young children should be supervised to ensure that they do not play with the appliance.
Installation Where to Install Unstable installation may cause vibration and noise. If the floor to install the refrigerator on is not even, make the refrigerator level by rotating the height adjusting screw. Strong and even floor A proper distance from adjacent items To ensure proper air circulation around the fridge -freezer, please maintain sufficient space on both the sides as well as top and maintain at least 2 inches (5 cm) from the rear wall.
Installation Door removal Warning Electric Shock Hazard Disconnect electrical supply to refrigerator before installing. Failure to do so could result in death or serious injury. If your entrance door is too narrow for the refrigerator to pass through, remove the refrigerator door and pass the refrigerator laterally. Remove lower cover and water feed tube Remove the lower cover by lifting upward, and then pull up the water feed tube while pressing the release ring shown in the figure to the right.
Installation Pass the refrigerator laterally through the access door as shown in the right figure. Pass the refrigerator Max 5 4 3 2 1 FRZ TEMP Min 1 2 REF TEMP 3 4 5 Max Door replacement Mount them in the reverse sequence of removal after they pass through the access door. Water supply installation Automatic icemaker operation needs water pressure of 147~834 kPa (1.5~8.5 kgf/cm2 ) (That is, an instant paper cup (180 cc) will be fully filled within 3 seconds.
Installation Height adjustment If the freezer compartment door is lower than the refrigerator compartment door Level them by inserting a flat ( - type) driver into the groove of the left height adjusting screw and rotating it clockwise (a). If the freezer compartment door is higher than the refrigerator compartment door Level them by inserting a flat ( - type) driver into the groove of the right height adjusting screw and rotating it clockwise (a).
Operation Setup When your refrigerator is first installed, allow it to stabilize at normal operating temperatures 2~3 hours prior to filling it with fresh or frozen foods. If operation is interrupted, wait 5 minutes before restarting. Adjusting the temperatures and functions NOTE • Your model may not include every option. • The control display is operated by touch. Excessive moisture on the display may cause a malfunction. Please keep display clean and dry.
Operation Display Power Saving Mode This function places the display into power saving mode until the next time the door is opened. Press the FREEZER and EXPRESS FREEZER buttons simultaneously and hold them for 5 seconds until the Ding sounds. All LCDs will then turn ON, then OFF. When the power saving mode is activated, the display will remain off until the next time the door is opened.
Operation How to use dispenser ■ Select among crushed ice, water, and cubed ice and press the push switch with a glass or other container. Crushed Ice Water Cubed Ice Light the crushed ice Light the water lamp by Light the cubed ice lamp by pressing the pressing the selection lamp by pressing the selection button. button. selection button. • Crushed ice will be • Water will be dispensed • Cubed ice will be dispensed by pressing the by pressing the push dispensed by pressing the push switch with a glass.
Operation Ice is lumped together ■ If the ice lumps together, take it out, break it apart, and put it back into the storage bin. ■ When the icemaker produces too small or lumped together ice, the amount of water supplied to the ice maker needs to adjusted. Contact the service center. When ice dispensing does not operate smoothly h If ice is not used frequently, it may lump together. Power failure ■ Water may drop from the refrigerator.
Operation This button stops operation of different button and dispenser function. ■ Locking or Release is repeated whenever the is pressed more than 3 seconds. ■ If you use the ALARM/LOCK button, none of the other buttons will work until you unlock them. LOCK UNLOCK Lock Door open warning ■ A warning tone will sound 3 times at thirty-second intervals if the refrigerator or freezer door is left open for more than sixty seconds.
Operation Ambient Temperature Display Window. Other functions ■ ■ Temperature is displayed only between -9 °C ~ 49 °C. Temperature less than -9 °C is indicated with LO and temperature more than 49 °C is indicated with HI. Diagnosis (failure detection) function The diagnostic function automatically detects failure when failure is found in product during the use of refrigerator. ■ If your refrigerator fails, do not turn off the power.
Operation Refreshment center (Applicable to some models only) Open the refreshment center door. ■ You can access the refreshment center without opening refrigerator door and thus saving electricity. ■ Inner lamp is lit in refrigerator compartment when the refreshment center door opens. Thus it is easy to identify the contents. How to use Use the refreshment center door as a stand ■ Never take out the inner refreshment center cover ■ The refreshment center can not function normally without the cover.
Operation Shelf (Applicable to some models only) The refrigerator compartment shelves are adjustable so you can locate them according to your needs. Shelf height adjustment ■ Slide Shelf Pull the shelf ahead and take off it while lifting both front and rear part. 2 3 1 ■ Fixed Shelf, Folding Shelf Lightly lift up the front part of shelf to pull it ahead and then take off it while lifting the rear part of shelf. 1 3 2 NOTE • Make sure the shelf is horizontal. If not, it may drop.
Operation Egg box (Applicable to some models only) You can move the egg box to a place you want and select another form of box according to the amount of eggs. [Normal] [For Many Eggs] NOTE • Never use the egg box as an ice storage bin. It can break. • Never store the egg box in the freezer compartment or fresh compartment. Humidity control in the vegetable compartment The humidity can be controlled by adjusting the humidity control switch to the left/right when storing vegetables or fruits.
Operation Miracle Zone Temperature Transition Corner (Applicable to some models only) By pressing the button, store vegetables, fruits or other types of food such as meat to be defrosted, raw fish, etc. Temperature Change at Miracle Zone (Applicable to some models only) Method to Use You can select optimum temperature range depending on types of foods stored. - 3-step of temperature selection including -3°C, -1°C and 4°C is available.
Operation Location of foods Snack drawer Store small foods such as bread, snacks, etc. Freezer compartment shelf Store various frozen foods such as meat, fish, ice cream, frozen snacks, etc. Freezer compartment door rack Store small packed frozen food. Items stored in the door racks don’t stay quite as cold as in the rest of the freezer. Store ice cream and similar items on a shelf in the freezer instead. Freezer compartment drawer Store meat, fish, chicken, etc. after wrapping them with thin foil.
Suggestion on food storage Storing foods Store fresh food in the refrigerator compartment. How food is frozen and thawed is an important factor in maintaining its freshness and flavor. ■ Do not store food which goes bad easily at low temperatures, such as bananas, and melons. ■ Allow hot food to cool prior to storing, placing hot food in the refrigerator could spoil other food, and lead to higher energy consumption. ■ When storing the food, cover it with vinyl wrap or store in a container with a lid.
Care and maintenance How to remove and replace parts NOTE • Dismantling is done in the reverse sequence of assembly. Be sure to unplug the power plug before dismantling and assembly. Never apply severe force to dismantle parts. Parts may be damaged. Freezer compartment lamp To remove the lamp cover, separate the shelf over the lamp cover and pull the lamp cover forwards b while pressing the bottom side of the lamp cover upwards a. Turn the bulb counterclockwise. Use a 40-watt bulb (max.
0 Upper lamp in refrigerator compartment To remove the lamp cover, pull the lamp cover forward while pressing the bottom side of the lamp cover upward. Turn the bulb counterclockwise. Use a 40-watt bulb (max.) which can be purchased at a service center. Lower lamp in refrigerator compartment Separate the lamp cover by holding both lower sides of it and pulling it it forwards. Turn the bulb counterclockwise. Use a 40-watt bulb (max.) which can be purchased at a service center.
Care and maintenance We recommend replacing the filter when the water filter indicator light turns on or your water dispenser or ice maker decreases noticeably. After changing the water filter cartridge, reset the water filter status display and indicator light by pressing and holding the BUTTON for 3 seconds. Filter replacement 1) Remove the old cartridge. Rotate the knob of the cartridge counter clockwise. When the cartridge is removed, you will feel it click out of place. Pull out the cartridge.
Care and maintenance General information Vacation time During average length vacations, you will probably find it best to leave the refrigerator in operation. Place freezable items in freezer for longer life. When you plan to store the refrigerator, remove all food, disconnect the power cord, clean the interior thoroughly, and block the doors open to prevent mold and mildew. Be certain the stored refrigerator does not present a child entrapment danger.
Care and maintenance Trouble shooting Before calling for service, review this list. It may save you both time and expense. This list includes common occurrences that are not the result of defective workmanship or materials in this appliance. Occurrence Possible cause Solution Normal Operations Refrigerator Refrigerator compressor does not run. Refrigerator runs too much or too long 25 Refrigerator control is off. Set refrigerator control. Refrigerator is in defrost cycle.
Care and maintenance Occurrence Possible cause Refrigerator compressor does not run. Solution Thermostat is keeping the refrigerator at a constant temperature. This is normal. The Refrigerator goes on and off to keep the temperature constant. Freezer control is set too cold Adjust the freezer control to a warmer setting until the freezer temperature is satisfactory. Temperatures are too cold Temperature in the freezer is too cold but the refrigerator temperature is satisfactory.
Care and maintenance Possible cause Occurrence Solution Sound and noise Louder sound levels when refrigerator is on. Today’s refrigerators have increased storage capacity and maintain more even temperatures. It is normal for sound levels to be higher. Louder sound levels when compressor comes on. Refrigerator operates at higher pressures during the start of the ON cycle. This is normal. The sound will level off as the refrigerator continues to run. Vibrating or rattling noise.
Care and maintenance Occurrence Possible cause Solution Odors in refrigerator Interior needs to be cleaned. Clean interior with sponge, warm water, and baking soda. Be sure the soda is completely dissolved so it will not act as an abrasive compound. Food with strong odor is in the refrigerator. Cover food completely. Some containers and wrapping materials produce odors. Use a different container or brand of wrapping materials. Food package is keeping door open.
Care and maintenance Occurrence Possible cause Dispenser will not dispense ice. Ice has melted and frozen around auger due to infrequent use, temperature fluctuations and/or power outrages. Remove ice storage bin, and thaw and the contents. Clean bin, wipe dry and replace in proper position. When new ice is made, dispenser should operate. Ice dispenser is jammed. Ice cubes are jammed between the ice maker arm and back of the bin. Remove the ice cubes that are jamming the dispenser.
Memo 30