Owner's Manual

7
Door replacement
Water supply installation
Pass the refrigerator laterally through the access
door as shown in the right figure.
■
Automatic icemaker operation needs water pressure of 147~834 kPa (1.5~8.5
kgf/cm
2
) (That is, an instant paper cup (180 cc) will be fully filled within 3 seconds.)
■
If water pressure is less than 147 kPa. It is necessary to purchase a separate
pressure pump for normal automatic icemaking and cool water feed.
■
Keep the total length of the feed water pipe tube within 8 m. Be careful for the tube
to avoid being kinked. If the tube is longer than 8 m, the pressure may drop to an
unacceptable level.
■
Install the water supply line where it will not be affected by heat.
■
Connect to potable water supply only.
■
Refer to instructions with water filter kit for installation.
This appliance contains fluids (refrigerant and lubricant) and is made of parts and
materials which are reusable and/or recyclable.
All the important materials should be sent to the collection center of waste material
and can be reused after rework (recycling). For recycling, please contact the local
agency.
Mount them in the reverse sequence of removal after they pass through the access
door.
Pass the
refrigerator
Before
installation
Warning
Disposal of the
old appliance
Installation