PREMTBVC0 Installation Manual

Installation Manual

Due to our policy of continuous product innovation, some specifications may change without notification.

ZigBee Pro Quick Setup

This quick set-up describes how to pair a ZigBee sensor with

a Remote Controller. Please see ZigBee Configuration section

of the MultiSITE CRC1 User Interface Guide if this is the first

time a sensor is being paired with the remote controller for

proper configuration of the ZigBee Wireless network.

1. Go to first Zone screen in Wireless Ecosystem section of

MultiSITE CRC1 Series Remote Controller's interface and

set “Permit join” to On. Permit join is only available on the

first Zone Screen but is applicable to all Zones.

2. Insert battery or remove pull tab (for contact sensors) to

activate ZigBee sensor. If sensor does not join ZigBee

wireless network press the button located on the sensor ten

(10) times to reinitialize joining process.

3. Verify sensor has joined network and Paired field status

reads Yes on Zone screen.

4. Use the “Set function to” control in the Zone Screen to

select sensor type (Motion, Window or Door).

5. Set Permit Join on MultiSITE CRC1 Series Remote

Controller to Off when pairing process is complete.

Troubleshooting

MultiSITE CRC1 Series Remote Controller User Interface

Guide is available at www.lghvac.com.

ZIGBEE SETUP