LMCN078HV Engineering Manual

Assigning the Thermistor for Temperature Detection

Each indoor unit includes a return air thermistor assigned to sense the temperature. If a wired controller is installed, there is a choice of

sensing temperature with either the indoor unit return air thermistor or the thermistor in the wired controller. It is also an option to set both

thermistors to sense temperature so that indoor unit bases its operation on the first thermistor to reach the designated temperature differen-

tial. For applicable indoor units, an optional Remote Temperature Sensor can be used in lieu of the return air thermistor—either alone or in

conjunction with a wired controller thermistor as previously described.

Finalizing Indoor Unit Installation

1. Verify that the side covers are closed or opened, depending on

installation requirements. Place the power wiring / communica-

tions cable in the bottom groove along the left side of the frame.

2. Reconnect the panel connector found at the top of the indoor unit.

3. Attach the top part of the front panel, then position its tabs in the

grooves on the bottom part of the indoor unit frame.

4. To ensure the front panel tabs are securely positioned in the

grooves, adjust the panel by loosening or tightening the screws

at the bottom.

Figure 59:Final Installation Step—Reattaching the Front Panel.

Front Panel

Connector

ART COOL GALLERY INDOOR UNITS

Installation and Best Layout Practices

Due to our policy of continuous product innovation, some specications may change without notication.

46 | ART COOL GALLERY™

Multi F and Multi F MAX Indoor Unit Engineering Manual

MULTI

MAX

MULTI