PREMTBVC0 Installation Manual

Installation Manual

Due to our policy of continuous product innovation, some specifications may change without notification.

CONTROLLER INSTALLATION

Installing the Controller

Follow this procedure to install the controller.

Note:

• If replacing an existing MultiSITE CRC1 Series Remote Controller, label the wires

before removal.

• Electronic controls are static sensitive devices. Discharge yourself properly before

manipulating and installing the Remote Controller.

• A short circuit or wrong wiring may permanently damage the Remote Controller or

the equipment.

• This Remote Controller must be installed to provide a separation distance of at

least 8 inches from all persons and must not be collocated or operating in conjunc-

tion with any other antenna or transmitter.

• If your installation includes wireless accessories, you can install the optional

ZigBee Pro wireless module when the controller case is open. Refer to page 17

for Zigbee Pro wireless module installation instructions.

• Maximum cable length is 164ft. Do not splice wiring.

• Cable Type: 3 conductor, 22 AWG, unshielded, twisted, and stranded.

• If the indoor unit does not have screw terminals for field wiring, Extension Cable

PZCWRC1 is required. The green Molex connector of this cable connects to the

IDU. The white Molex connector of this cable is removed and the wires connected

to the Remote Controller as described below.

Figure 3: Open Cover

1. Remove security screw (if any) on

bottom of Remote Controller cover

(Figure 3).

2. Read FCC ID and IC label installed

in cover before installing any wire-

less product.

3. Ensure correct side of base faces up.

4. Pull cable 6 inches out from wall.

5. Align base and mark location of two

mounting holes on wall

(Figure 4).

6. Install anchors in wall.

7. Insert communication cable through

center opening of base.