PREMTBVC0 Installation Manual

MultiSITE CRC 1 Controller

Due to our policy of continuous product innovation, some specifications may change without notification.

Note:

Clean up the site after all procedures are nished, and check that no metal

scraps, screws, or bits of wiring have been left inside or surrounding the

controller or indoor units.

Provide power to the outdoor unit compressor crankcase heaters at least

six (6) hours before operation begins.

Starting operation with a cold compressor sump(s) may result in severe bearing damage

to the compressor(s). Keep the power switch on during the operational season.

Do not block the indoor unit inlet or outlet.

Unit may malfunction.

Securely attach the electrical cover to the indoor unit. Non-secured covers

can result in re due to dust or water in the service panel.

Do not allow water, dirt, or animals to enter the unit.

There is risk of unit failure or degraded performance.

Do not spill water or other liquid on the inside of the indoor unit, espe-

cially on electrical components.

Do not drop the MultiSITE Controller unit into water. If the unit is im-

mersed in water or other liquid, contact your local authorized LG distributor

for support.

There is risk of unit failure or degraded performance.

Electronic controls are static sensitive devices.

Discharge yourself correctly before manipulating and installing the MultiSITE Controller.

This device must be installed to provide a separation distance of at least

8 inches from all persons and must not be located or operating in conjunc-

tion with any other antenna or transmitter.

Operation is subject to the following two conditions: (1) this device may

not cause interference, and (2) this device must accept any interference,

including interference that may cause undesired operation of the device.

A short circuit or wrong wiring may permanently damage Remote Control-

ler or equipment.

SAFETY INSTRUCTIONS