Installation Manual

Installation Manual 19
Connecting the Cable between Indoor Unit and Outdoor Unit
ENGLISH
WARNING: Loose wiring may cause the terminal to overheat or result in unit
malfunction. A fire hazard may also exist. Therefore, be sure all wiring is tightly
connected.
When connecting each power wire to the corresponding terminal, follow instructions "How to connect
wiring to the terminals" and fasten the wire tightly with the fixing screw of the terminal plate.
How to connect wiring to the terminals
◼ For strand wiring
(1) Cut the wire end with a wire cutter or wire-
cutting pliers, then strip the insulation to expose
the strand wiring about 10 mm(3/8").
(2) Using a screwdriver, remove the terminal
screw(s) on the terminal plate.
(3) Using a round terminal fastener or pliers,
securely clamp each stripped wire end with a
round terminal.
(4) Position the round terminal wire, and replace
and tighten the terminal screw using a
screwdriver.
Power supply cable
Connecting Cable
Strip 10 mm(3/8")
Round
terminal
Connecting cable
Loosening the
terminal block
screw
Fastening the
wire tightly
Strand wire