Multi F Outdoor Condenser Installation Manual

32
MULTI F / MULTI F MAX Outdoor Unit Installation Manual
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG” is a registered trademark of LG Corp.
MULTI
F
MAX
MULTI
F
Bottom of Unit
Wall
Bottom View, Port End Facing Up
PCB
Bott
Figure 20: Acceptable Branch Distribution Unit Orientation.
Wall Mounting Options
Wall
Bottom View, Port End Down
PCB
PCB
Wall
Bottom
of Unit
PCB
Wall
Bottom View, Port End Facing Right
Bottom
of Unit
Bottom of Unit
Into the
Wall
Into the Unit
Into the Unit
Into the Wall
Into the Wall
Bottom of Unit
Isometric View
Bottom View, Port End Facing Left
Wall
Left Side View, Port End Facing Left
Wall
Top of Unit
Top of Unit
Right Side View, Port End Facing Right
Figure 21: Unacceptable Branch Dis-
tribution Unit Wall Mount Orientations.
1. Attach the factory-supplied
hangers with two (2) screws
each at the designated four
(4) areas on the frame of the
branch distribution unit.
2. Install the branch distribution
unit to the wall using two
screws on each of the hang-
ers. Unit must be ±5 degrees
of level.
3. Cover parts of the hanger
holes with polyethylene
foam insulation (to prevent
condensation).
02817,1*$1&+25,1*
THE BRANCH DISTRIBUTION UNITS
Figure 19: Acceptable Branch Distribution Unit Ceiling Mount Orientations.
Left Side View,
Port End Facing Left
Ceiling Mounting Options
Port End View
Right Side View,
Port End Facing Right
Ceiling Ceiling
Ceiling
Top of Unit
Refrigerant Piping End View
Ceiling
Top of Unit
Top of Unit
Top of Unit
Top of Unit
Into the Ceiling
Into the Unit
Into the Ceiling
Into the Unit
Into the Unit
Into the Ceiling
Isometric View
Wall Mount Installation - Hangers Only
Ceiling Mount Installation, continued.