Multi F Engineering Manual

STD. WALL-MOUNTED | 67
Standard Wall-Mounted
'XHWRRXUSROLF\RIFRQWLQXRXVSURGXFWLQQRYDWLRQVRPHVSHFL¿FDWLRQVPD\FKDQJHZLWKRXWQRWL¿FDWLRQ
©/*(OHFWURQLFV86$,QF(QJOHZRRG&OLIIV1-$OOULJKWVUHVHUYHG³/*´LVDUHJLVWHUHGWUDGHPDUNRI/*&RUS
MULTI
F
MAX
MULTI
F
Installation and Best Layout Practices
Hanging the Indoor Unit Frame
1. Attach the three (3) hooks on the top of the indoor unit to the top edge of the instal-
lation plate. Verify the hooks are properly attached to the installation plate by gently
shaking the indoor unit from side to side.
2. Unlock the tubing clamp from the indoor unit frame. For easier access between the
bottom of the indoor unit and the wall, prop the clamp between the indoor unit frame
and installation plate.
3. Remove the screw covers at the bottom of the indoor unit, unscrew the two (2) screws,
remove the frame cover, remove the piping connection cover, and position the piping
for installation (down, back, left, or right).
Preparing for Installation
Prepare the refrigerant piping and drain hose (indoor unit piping) for installation through the
ZDOOSUHVVRQWKHWRSRIWKHWXELQJFODPSDQGVORZO\JXLGHWKHSLSLQJKRVHGRZQGHSHQGLQJ
on installation requirements, then to the left or right). Relock the tubing clamp after the piping /
hose are released.
Note:
Do not bend the piping / drain hose from side to side; it will damage the components.
)LJXUHPreparing for Installation.
Installation plate
)LJXUHLocking the Indoor Unit onto the Installation Plate.
Tubing Clamp
)LJXUHAccessing the Back of the Indoor Unit.
Right
Tubing Clamp
Down
Left
Back
Frame Cover
)LJXUHRemoving the Frame Cover.
)LJXUHExterior Back View of Indoor Unit.
)LJXUHPiping Installed to the Left.
)LJXUHPiping Installed to the Right.
Connecting
pipe
Tape
Drain hose
Connecting
pipe
Tape
Drain hose
STANDARD WALL-MOUNTED INDOOR UNITS