Owner's Manual

Installation
8
A
A
Bend the claws
according
to
the thickness
of the
dashboard
Front
panel
Front
panel
Basic Installation
Before
installing,
make sure that the
ignition
switch is set to
OFF and remove the terminal of the car
battery
to avoid
short-circuiting.
1 Remove the
existing
receiver unit.
2 Make the
necessary
connections.
3 Install the installation sleeve.
4 Install the unit into the installation sleeve.
Removing
the
existing
receiver unit.
If there is
already
an installation sleeve for the receiver unit in
the
dashboard,
it must be removed.
1 Remove the rear
support
from the unit.
2 Remove the front
panel
and trim
ring
from the unit.
3 Insert the lever
A
into the hole on one side of the unit.
Perform the same
operation
on the other side and
pull
the
unit out from the
mounting
sleeve.
ISO-DIN Installation
1 Slide the unit into the ISO-DIN frame.
2 Install screws removed from the old unit.
3 Slide the unit and frame into the dash
opening.
4 Install the dash
panel
or
adapter plate.
5 Install the trim
ring
into unit.
6 Install the
faceplate by fitting
the
right edge
into
position
then
pushing
the left
edge
closed.