Owner's Manual

1 Select “Rating” on the Lock menu then press
ii
(B on the remote control).
2To access the Rating, Password and Area Code features, you must input the 4-digit
security code you created. If you have not yet entered a security code you are prompted to
do so.
Input a 4-digit code and press ENTER. Enter it again and press ENTER to verify.
If you make a mistake before pressing ENTER, press
II
(
b on the remote control).
3 Select a rating from 1 to 8 using the
UU
/
uu
(
v/V on the remote control).
Rating 1-8
Rating one (1) has the most restrictions and rating eight (8) is the least restrictive.
Unlock
If you select unlock, parental control is not active and the disc plays in full.
4. Press ENTER to confirm your rating selection.
Note
If you set a rating for the player, all disc scenes with the same rating or lower are played.
Higher rated scenes are not played unless an alternate scene is available on the disc.
The alternative must have the same rating or a lower one. If no suitable alternative is found,
playback stops. You must enter the 4-digit password or change the rating level in order to play
the disc.
Password
You can enter or change password.
1. Select Password on the Lock menu and then press
ii
(B on the remote control).
2. To make a new password:
Press ENTER when the “New” option is highlighted. Enter a new password using the
numerical buttons then press ENTER. Enter the password again to verify.
To change the password:
Press ENTER when the “Change” option is highlighted. Enter a current password using the
numbered buttons then press ENTER. Enter a new password using the numbered buttons
then press ENTER. Enter the password again to verify.
If you forget your password
If you forget your password you can clear it using the follow steps.
1. Press DVD SETUP (Press and hold DISC MENU/SETUP on the remote control) to
display the Setup menu.
2. Input the 6-digit number “210499” and the password is cleared.
3. Enter a new code as described above.
Area code
Enter the code of the area whose standards were used to rate the DVD video disc, according
to the area code list on the page 34.
1. Select “Area Code” on the Lock menu then press
ii
(B on the remote control).
2. Follow the step 2 as shown on the page 23 (Rating).
3. Select the first character using
UU
/
uu
(
v/V on the remote control).
4. Press ENTER and select the second character using
UU
/
uu
(
v/V on the remote
control).
5. Press ENTER to confirm your area code selection.
23