User Guide

12 | INTRODUCTION
Single Zone Art Cool Premier Owner’s Manual
Due to our policy of continuous product innovation, some specications may change without notication.
UNIT OPERATION
Initializing Remote Controller Operation
To begin communication between the indoor unit and the remote controller, point the remote controller towards the signal receiver,
located at the bottom right hand corner of the indoor unit (see Figure 8).
•Make sure to point the remote controller directly at the indoor unit, otherwise
the remote might accidentally activate and operate other electronic devices
due to the signal being picked up.
•For optimum operation, periodically use a soft cloth to wipe the signal trans-
mitter on the remote controller and the receiver on the indoor unit.
•Jet mode in heating operation doesn’t work when equipped with a wired
remote controller.
•ON/OFF reserve mode doesn’t work when equipped with a wired remote
controller.
Remote Controller, Indoor Unit
Figure 8: Initializing Remote Controller