User Guide

INTRODUCTION | 15
Operation
Due to our policy of continuous product innovation, some specications may change without notication.
ADVANCED FUNCTIONS
Jet Cool/Heat Operation -
Auto Changeover Operation
Follow the operational directions in this section to work with advanced functionality and features of the Art Cool Premier Wall Mounted system.
Jet Cool/Heat Operation
Rapid Cooling and Heating of Room Temperature
This functionality allows you to rapidly cool indoor air (during sum-
mer months) or warm indoor air (during winter months).
1. Press to turn on the power.
2. Press the Jet Mode button .
•In jet cool mode, unit operates at a setpoint of 64.4 °F (18 °C) for a
duration of 30 minutes.
•In jet heat mode, unit operates at a setpoint of 86 °F (30 °C) for a
duration of 30 minutes.
•Jet cool/heat mode cannot be run during air circulation, auto, or auto
changeover modes.
•This function may not be supported on all Single Zone Inverter models.
Auto Clean Operation
Indoor Air Purification
While in cooling and dehumidifying mode, the air conditioner gener-
ates moisture on the interior of the indoor unit. The auto clean
operation is used to remove this type of moisture.
1. Press to start dehumidifying operation.
• is displayed on the remote controller display screen.
•If the power is turned off, the fan will operate for 30 minutes and will
clean the inside of the indoor unit.
•Some buttons (functionality) will not operate while the system is in
auto cleaning mode.
Auto Operation
(Cooling Only Models)
During this functionality, the fan speed and the temperature adjust
automatically, based on room temperature.
1. Press to turn on the power.
2. Press the Mode button repeatedly to select auto operation
(see icon in Figure 9 below).
3. Press the up and down arrows to select the desired
numerical operation code for cooling/heating strength. See the
table in Figure 9 below for a description of each numerical value.
•During the auto operation mode, you cannot adjust the fan speed.
•Duringthismode,youcansettheairdeectortorotateautomatically.
•This function may not be available on all models.
Code Description
2 Cool
1 Cool slightly
0 Maintain
room
temperature
-1 Heat slightly
-2 Heat
Figure 9: Auto Intelligence Screen with Code Description
Auto Changeover Operation
This functionality changes the operation mode automatically to main-
tain a set temperature of ± 3.6 °F (±2 °C).
1. Press to turn on the power.
2. Press the Mode button repeatedly to select auto operation
(see icon display in box in Figure 10 below).
3. Press the up and down arrows to select the desired
temperature.
•The temperature range is 64.4 °F (18 °C) through 86 °F (30 °C).
4. Press repeatedly as needed to adjust the fan speed.
Auto Changeover
Figure 10: Auto Changeover Display
•This function may not be supported on all models.
•Your screen display may look slightly different depending on your model.
°C/°F Screen Display
The Single Zone Art Cool Premier unit can be set in either °C or °F
temperature readout, by pressing and holding the Room Tem-
perature button for 5 seconds.
This function may not be available on all models.