Owner's Manual

30
1) Arrange 2 power cables on the control panel.
2) First, fasten the steel clamp with a screw to the inner boss of control panel.
1) Connecting cables to the Indoor Unit
Connect the wires to the terminals on the control board individually according to the
outdoor unit connection.
 Ensure that the color of the wires of outdoor unit and the terminal No. are the same as
those of indoor unit respectively.
2) Clamping of cables
3) For the cooling model, fix the other side of the clamp with a screw strongly.
If the supply cord is damaged, it must be replaced by a special cord or assembly availible from the manufacturer of its service agent.
The connecting cable connected to the indoor and outdoor
unit should be with the following specifications
/YL
2
(36K/60K)
NORMAL CROSS-SECTIONAL AREA
Capacity
The power cord connected to the outdoor unit should be
with the following specifications
20mm
G
N
NORMAL
CROSS-SECTIONAL
AREA
1.25mm
20mm
G
N/Y
L
36K BTU/h
60K BTU/h
3 Phase
2.5mm
3.5mm
Make sure that the screws of the terminal are free from looseness.
WARNING
6. Connecting Cables between Indoor and Outdoor Unit
Please do the interconnection as per Interconnection Table in wiring diagram.
CAUTION