Owner's Manual
1.The following should be always observed for safety............................... 3
2. Installation of Indoor, Outdoor Unit........................................................... 4
3. Connecting Pipes to the Indoor Unit........................................................15
4. Connecting Pipes to the Outdoor Unit.....................................................17
5. Checking the Drainage...............................................................................17
6. Connecting Cables between Indoor Unit and Outdoor Unit.................. 27
7. Air Purging of the Connecting Pipes and the Indoor Unit..................... 30
8. Group Control ............................................................................................ 31
9. Two Thermistor System............................................................................. 31
OUT-LINE OF INSTALLATION
Installation works Installation Parts Required tools
1)
Selection of the best
location
............................4
2) Indoor unit installation....
5
•
Four Ty pe “A” screws
•
Connecting cable
•
Level
•
Screw driver
•
Electric drill
•
Hole core drill (ø70mm)
1) Preparation of Piping...15
•
Pipes: Gas side ..... 3/4", 5/8", 7/8", 1-1/8"
Liquid side ............. 1/4", 1/2", 5/8", 3/4"
•
Insulated drain hose
•
Insulation materials
•
Flaring Tools set
1) Connecting the pipes to
the Outdoor Unit ..........17
•
Additional Drain hose
(Inner Dia...............25mm)
1) Connecting cables to the
Indoor Unit ...................27
2) Connecting cables to the
Outdoor Unit ................28
3) Form the pipings..........29
•
Screw driver
•
Hexagonal Wrench (4mm/5mm)
•
Gas-leak Detector
3
•
Pipe is to be used for
installing 5.5 TR