Owner’s Manual

11OPERATION
ENGLISH
2 Press and hold the Forced Operation button
a for 6 seconds.
3 When the appliance beeps twice, release the
Forced Operation button
a. The product will
beep twice and the blue lamp will blink 4
times.
Type 1
Type 2
NOTE
• This feature may change depending on the
model type.
• If you press and hold the Forced Operation
button
a for 3 - 5 seconds, instead of 6 seconds,
the appliance will switch to the test operation. In
this test operation, the appliance blows out
strong cooling air for 18 minutes and then
returns to factory default settings.
Preparing before Operation
Inserting the Batteries into the
Wireless Remote Control
Insert AAA (1.5 V) batteries into the wireless
remote control.
• Remove the battery cover and insert the new
batteries, making sure that the + and – terminals
of the batteries are oriented correctly.
NOTE
• When the wireless remote control display begins
to fade, replace the AAA (1.5 V) batteries.
• Do not use old and new batteries together.
Installing the Remote Control
Holder
1 Choose a suitable place where its safe and
easy to reach.
2 Fix the firmly to the wall with the supplied
screws.
3 Slide the remote controller inside the holder.
NOTE
• The remote controller should never be exposed
to direct sunlight.
• The signal transmitter and receiver should
always be clean for proper communication. Use
a soft cloth to clean them.
• If other appliances are accidentally affected by
the remote controller, change their position or
consult your serviceman.
Setting the Current Time on the
Wireless Remote Control
1 Insert the batteries.
• The time flashes at the bottom of the
display screen.
2 Press and hold the Set/Clear button for about
3 seconds.