Owner’s Manual

14
OPERATION
Auto Changeover Mode - Setting
the Mode Change Temperature
Cooling & Heating Model
The Mode Change Temperature is the difference of
temperature when from cooling mode to heating mode
or from heating mode to cooling mode.
1
In Auto Operation Mode, Press the FUNC. button to
select Setting the Mode Change Temperature.
2
Press or button to set desired Mode Change
Temperautre.
• Default value is 2 °C (4 °F)
• Setting temp range: 1 °C ~ 7 °C (2 °F ~ 14 °F)
NOTE
• When setting temperature is 25 °C (76 °F) and room
temperature is 20 °C (68 °F), then operating mode is
heating. If you set the mode change temperature to
2 °C (4 °F), when the room temperature up to
27 °C(25 °C + 2 °C) (80 °F(76 °F + 4 °F), the unit start
cooling operation.
Using the Temperature
Setting Function
Temperature Setting
Use this function to adjust the desired temperature.
: Increase 1 ˚C or 1 ˚F each time pressed.
: Decrease 1 ˚C or 1 ˚F each time pressed.
NOTE
• 5 °C (41 °F) is proper for the difference between room
and outside temperature.
• Cooling operation
− The cooling mode doesn’t work if the desired
temperature is higher than room temperature.
Please lower the desired temperature.
− Setting temp range: 18 °C ~ 30 °C (64 °F ~ 86 °F)
• Heating operation
− The heating mode doesn’t work if the desired
temperature is lower than room temperature.
Please increase the desired temperature.
− Setting temp range: 16 °C ~ 30 °C (60 °F ~ 86 °F)
− When pressing the FAN SPEED button of the
remote controller for approx. 3 seconds, the room
temperaturewill be displayed for about 5 seconds
before returning to the previous display panel.
• Some functions may not be supported, depending on
the model.
Switching Between Celsius/
Fahrenheit
• Press and hold the ROOM TEMP or FUNC. button
long for 5 seconds to change from Celsius to
Fahrenheit or from Fahrenheit to Celsius.
NOTE
• Some functions may not be supported, depending on
the model.