Owner’s Manual

ENGLISH

FRANÇAIS ESPAÑOL

OPERATION

Using Wireless Remote Control

Button Display Button Description

- Used to turn on/off the unit.

FUNC. -

Used to set or clear Auto Clean, Smart Clean, Electric heater or Individual vane

angle control.

VANE

ANGLE

Used to set each vane angle.

PLASMA Used to start or stop the plasma-purification function.

- Used to select the room temperature.

MODE - Used to select the operation mode.

JET MODE - Jet Cooling sets the fan to operate at a super high speed.

FAN SPEED - Used to set the fan speed at one of four speeds: low, medium, high and chaos.

AIR FLOW - Used to set airflow.

Used to stop or start louver movement and set the desired up/down airflow

direction.

- Used to set the desired left/right (horizontal) airflow direction.

ROOM TEMP - Used to select the room temperature.

SLEEP - Used to set the time for the sleep function.

ON - Used to set the start time.

OFF - Used to set the stop time.

Used to set the timer. Used to adjust the brightness. (If it is not time adjust

mode)

SET/CLEAR -

Used to set/clear the timer. Used to set the current time. (hold button for 3

seconds)

NOTE

• Depending on the product type, some functions may not be available and displayed.

• Some products don’t receive the wired signals.

• When using the simultaneous operation system, the system will operate approximately 1 - 2 minutes after

pressing the remote controller button.

• The displayed temperature can be different from the actual room temperature if the remote controller is

installed somewhere exposed to direct sunlight or is nearby a heat source.

• Depending on the product, wireless and wired remote control are optional or basic.

• Operation Modes : Cooling Mode → Auto Operation → Dehumidification Mode → Heating Mode → Fan Mode.

• Heating Mode is not available for Cooling only Models.