Owner’s Manual
ENGLISH
FRANÇAIS ESPAÑOL
17
OPERATION
Using the Air Purification
Function
Plasma Purification (Optional)
1
Turn the appliance on.
2
Press the PLASMA button.
NOTE
• If you wish to stop, press the PLASMA button
again.
Plasma Purification only (Optional)
• Press the PLASMA button.
NOTE
• Plasma filter is a technology developed by LG to
get rid of microscopic contaminants in the intake
air by generating a plasma of highly charged
electrons. This plasma kills and destroys the
contaminants completely to provide clean and
hygienic air.
• This function can be used in any operation mode
and any fan speed can be used while the plasma
filter is functioning.
Forced Operation
Forced operation is used when the remote controller
can’t be used.
• The operation will be started if the ON/OFF button
is pressed.
Type 1 Type 2
Forced Operation Button
Test Operation
During the TEST OPERATION, the unit operates in
cooling mode at high speed fan, regardless of room
temperature, and resets after 18 minutes. During test
operation, if the remote controller signal is received,
the operation, if the remote controller signal is
received, the unit can be set by the remote controller.
If you want to use this operation, Press and hold the
ON/OFF button for 3~5 seconds, then the buzzer
sound 1 will ‘beep’. If you want to stop the operation,
re-press the button.
Auto Restart Function
This function is useful in the case of power failure.
When power regains after a failure this feature
restores the previous operating condition and the air
conditioner will run in the same settings.
NOTE
• This feature is enabled by the factory default
settings, but you can disable it by pressing and
holding the ON/OFF button for 6 seconds. The unit
will beep twice and the lamp will blink 8 times.
• To enable it, press the button again for 6 seconds.
The unit will beep twice and the blue lamp will blink
4 times.