Owner’s Manual

ENGLISH
FRANÇAIS ESPAÑOL
19
OPERATION
How to Set Air Quality Level
Color (Optional)
1
With the JET COOL button pressed, press the reset
button.
JET
COOL
2
By using the or button, set function code and
setting value.
Function code
Setting code
3
Press the button toward the indoor unit 1 time.
• Each countries have different standards for
indicating Overall air quality. Please refer to table
below.
Value Step Overall Air Quality
Type 1
(1 beep)
4 step
(For Korea)
Good/Moderate/
Unhealthy/Poor
Type 2
(2 beep)
4 step
(For Global)
Good/Moderate/
Unhealthy/Poor
Type 3
(3 beep)
6 step
(For China)
Good/Moderate/
Unhealthy/Poor/
Very Poor/ Severe
4
Reset the remote controller to use the general
operation mode.
NOTE
• The feature may be changed according to the type of
model.
• Some functions may not be supported, depending on
the model.
Using Special Functions
Setting Special Functions
1
Press FUNC. button repeatedly to select the
desired function.
2
Press SET/CLEAR button to finish.
NOTE
• Some functions may not be supported, depending on
the model.
• Some functions may operate differently from the
remote control display.
Canceling Special Functions
1
Press FUNC. button repeatedly to select the
desired function.
2
Press SET/CLEAR button to cancel the function.
Auto Clean (Optional)
In the Cooling and Dehumidification Mode, moisture is
generated inside the indoor unit. This function removes
such moisture.
• is displayed on the display screen.
NOTE
• If you turn off the unit, the fan continues to run for 30
minutes and cleans the inside of the indoor unit.
• Some functions cannot be used while the Auto Clean
function is in operation.