Owner’s Manual

26
MAINTENANCE
Cleaning the PM1.0 Sensor
(Optional)
PM1.0 Sensor
1
Remove the PM1.0 Sensor corner cover on the
front panel.
2
Open the PM1.0 sensor case on the side of the
PM1.0 Sensor case and remove the rubber cap.
3
Use a cotton swab to wipe the dirt off the lens, and
then use a dry swab to remove the moisture.
4
Tighten the rubber cap, close the PM1.0 sensor
case, and assemble the PM1.0 Sensor corner cover
to its original position.
Rubber Cap
PM1.0 Sensor Case
WARNING
• For safety, turn off the main power switch.
• Be careful not to drop the product when removing
the PM1.0 Sensor corner cover.
• Be careful of falling accidents when cleaning the
PM1.0 sensor.
NOTE
• It is recommended to clean it every six months.
(assuming 8 hours of daily use)
• PM1.0 Sensor is only included with Air purification
panel.
• The feature may be changed according to the type of
model.
• Some functions may not be supported, depending on
the model.