Owner’s Manual

ENGLISH
FRANÇAIS ESPAÑOL
15
OPERATION
Smart Mode
It is the function to set the Smart Mode operation of
the product.
1
Press the AIR FLOW button repeatedly until
icon displayed.
2
Press the SET/CLEAR button to set or cancel this
function.
NOTE
• Smart Mode function can only be selected in the
cooling and heating modes.
• Smart Mode / Energy Saving Cooling / Refresh
Mode functions cannot be set at the same time.
• The above function may not be supported by some
products.
Refresh Mode
It is the function to set the Refresh Mode operation of
the product.
1
Press the AIR FLOW button repeatedly until
icon displayed.
2
Press the SET/CLEAR button to set or cancel this
function.
3
When set, it is displayed with the animated effect in
the order of
→→
.
NOTE
• Refresh Mode function can only be selected in the
cooling and heating modes.
• Smart Mode / Energy Saving Cooling / Refresh
Mode functions cannot be set at the same time.
• The above function may not be supported by some
products.
Using Special Functions
Individual vane angle control
(Optional)
This is the function that controls the 4 vane angles
individually in the 4-way ceiling cassette products.
1
Press the VANE ANGLE button.
• The individual vane angle control symbol will
blink.
2
Set each vane angle by pressing the VANE ANGLE
button.
3
Press the SET/CLEAR button to reserve or cancel
the individual vane angle control function.
NOTE
• There may be differences between the up/down/
left/right buttons on the wireless remote controller
and the wind discharge port directions.
• Set the desired angle while checking the movement
and angle of the product’s vanes.
• The individual vane control function is an additional
function of a product, and it may not work in some
products.