User guide

5
Introduction
Introduction
About Dome Camera
The dome cameras are designed for installation in an
indoor or outdoor video surveillance system.
The camera incorporates the digital signal processor,
pan/tilt mechanism, x28 zoom lens and RS-485
communication interface in a compact outdoor enclosure.
Features
m High Sensitivity Support
The camera provides the high quality picture with 4.5
mm (1/4 Type) Super HAD II CCD.
m Preset Position
Preset position is the function to register camera
monitoring positions (preset positions). By using
LKD1000 controller, you can register presets with
position number. Maximum 128 Preset Position are
available. By entering the position numbers, you can
move cameras to the preset positions. The moving
speed and holding time are adjustable.
m Preset Tour
Preset Tour is the function to go through all the
registered camera monitoring positions (preset
positions).
m Preset Group Tour
A preset tour is composed of a group of preset
positions that the operator can program to be linked
together in a sequence. A preset group should have a
maximum of 9 preset positions.
m Pattern recording function
A routine of manual operations can be stored and
reproduced repeatedly. The Pan, Tilt and Zoom
controls are available for pattern recording.
Note:
The available total time of pattern differs depending
on camera’s operation. When the pattern recording is
full, the pattern recording will automatically stop.
m Privacy Mask
Privacy zone feature enables users to veil unwanted
zones. This setting is used for masking unwanted
zones, hiding them from display on the monitor
screen. Up to 8 zones can be registered.
m Auto Pan
The camera has an Auto Pan function that enables to
keep surveillance on every detail occurring around
the specific area, which is preset to watch in advance.
The camera can pan among the maximum 8 points
you will set. The moving speed and holding time are
adjustable.
m Auto Flip
When the camera is operated to tilt through the 90°, it
can be watched the opposite side of the locations by
Auto Flip of a 180° horizontally.
m Optical Zoom
The optical zoom range is 1x to 28x.
m Digital Zoom
Digital zoom enhances the systems zoom range to 12
times beyond the 28x optical zoom limit. By utilizing
the digital zoom function, the total system zoom
range increases further from 28x (1x digital zoom) to
336x (12x digital zoom)
m Sensor Linkage
The camera is capable of capturing a subject by the
focus of camera moving promptly toward the subject
at the rate of 120° / s when the camera works with
a detector (magnetic, beam, infrared rays), and a
subject moving within a detection area is captured by
a detector.
m Alarm In function
Alarm input signals are supplied from external devices
through the ALARM IN connector to activate 'go to
preset' function.
m Controls by General Controller
This camera can be controlled by RS-485. Especially
the camera has an excellent cost-saving effect
because it can be controlled by the general RX point
of contact signal.
m Connects with the maximum 256 cameras
This camera can be utilized after being connected
with maximum 256 cameras.
Therefore, it is capable of performing an excellent job
in the large buildings or department stores.