User guide

Installation
13
3
Installation
Alarm In Data Terminal
Description Color
ALARM IN 1 Pink
ALARM IN 2 Gray
ALARM IN COM
Yellow
ALARM IN 3 White
ALARM IN 4 Violet
Alarm Input function
This speed dome camera has a terminal that can sense the
alarm signals.
If the alarm sensor that has installed in a door, window,
safe etc. sense a touch or shock, the alarm sensor send the
alarm signal to the camera and the camera will observe the
sensed position.
Change the observe position to a sensor that senses a
touch or shock then return to the position that previously
observed. (Set the Duration Time of Alarm Input function
to “3 to 255”.)
Function status Mode
While observe a
specific position.
Change the observe position to the
alarmed position then return to the
position that previously observed.
While operating
Preset Tour
function.
Stop preset touring and change the
observe position to the alarmed
position then restart the preset
touring again.
While operating
Auto Pan function.
Stop auto panning and change the
observe position to the alarmed
position then restart the auto
panning again.
While operating
Pattern function.
Stop operating pattern function
and change the observe position
to the alarmed position during the
dwell time then restart the pattern
function again.
in case of HOME
POSITION is ON.
After Alarm has been cleared and
finished the dwell time, it moves to
the HOME POSITION and spend the
dwell time at that position.
Do not connect one alarm sensor to the several
camera’s alarm input connector.
,
Note