Owner's Manual English, Spanish 08/25/2021 25662K
Table Of Contents
- PRODUCT FEATURES
- SAFETY INSTRUCTIONS
- PRODUCT OVERVIEW
- INSTALLATION
- Installation Parts and Tools
- Installation Overview
- Product Dimensions
- Product Specifications
- Preparing Cabinet Opening
- Preparing Water and Electrical Connections
- Preparing Dishwasher
- Attaching Installation Brackets
- Sliding Dishwasher into Cabinet Opening
- Connecting Water Supply Line and Power
- Connecting Drain Hose
- Leveling Dishwasher
- Securing Dishwasher to Cabinet Opening
- Final Installation Check
- OPERATION
- SMART FUNCTIONS
- MAINTENANCE
- TROUBLESHOOTING
- LIMITED WARRANTY
- CARACTERÍSTICAS DEL PRODUCTO
- INSTRUCCIONES DE SEGURIDAD
- DESCRIPCIÓN GENERAL DEL PRODUCTO
- INSTALACIÓN
- Piezas y herramientas para la instalación
- Descripción general de la instalación
- Dimensiones del producto
- Especificaciones del producto
- Preparación de la abertura para el gabinete
- Preparación de las conexiones eléctricas y de agua
- Preparación del lavavajillas
- Colocación de los soportes de instalación
- Deslizamiento del lavavajillas en la abertura del gabinete
- Conexión de la línea de suministro de agua y energía eléctrica
- Conexión de la manguera de desagüe
- Nivelado del lavavajillas
- Sujeción del lavavajillas en la abertura del gabinete
- Verificación final de la instalación
- FUNCIONAMIENTO
- FUNCIONES INTELIGENTES
- MANTENIMIENTO
- SOLUCIÓN DE PROBLEMAS
- GARANTÍA LIMITADA
51TROUBLESHOOTING
ENGLISH
Problem Possible Cause & Solution
Dishwasher chimes if
panel is touched during
operation.
Bumping into or touching the control panel during operation may result in
a disabled button sound. Only the Power, Start, and Control Lock buttons
are enabled during operation to prevent cycle settings from being changed
inadvertently.
• Button sounds can be turned off by pressing and holding Half Load for three
seconds.
• The end of cycle chime and safety alert sounds will still sound.
Dishwasher did not finish
cycle.
Door was opened during cycle.
• If the door is opened during a cycle, the Start key must be pressed within 4 minutes
or the machine turns off and all settings are lost.
Leaking in front of unit
Dishwasher not leveled properly.
• Verify the unit is level from side to side and from front to back. See leveling
instructions in the Installation section.
Wrong detergent used.
• If excessive sudsing is causing the leak, allow the foam to subside for 24 hours
then clean the inside of the tub with milk.
P1, P2, P3, or P4 appears
in display.
The Download cycle is selected.
• This is not an error code. This code indicates the current Download cycle.
n:#, U:#, d:#, t#
appearsin display.
(# = a number)
Test mode is selected.
• This is not an error code. This code is used when testing the dishwasher. Power the
unit off and on and the code will disappear.
L0, L1, L2, L3 or L4
appears in display.
Rinse Aid Level setting mode is selected.
• This is not an error code. This code indicates the current rinse aid level. For more
information, refer to the Adding Cleaning Agents section.
CL appears in display.
Control Lock is activated.
• This is not an error code. This code indicates that the control lock is activated. Press
and hold Half Load and Energy Saver simultaneously for three seconds.