Owner’s Manual

36 MAINTENANCE
Cleaning the Air Gap
1 Turn off the dishwasher.
2 Remove the air gap cover and the plastic cap
underneath it.
3 Clean out any debris with a toothpick or
brush.
4 Replace the plastic cap and air gap cover.
Cleaning the Filters
WARNING
• Be cautious of sharp edges when handling the
stainless steel filter.
CAUTION
• Remove food residue caught in filters to prevent
the buildup of odor-causing bacteria and
possible drainage problems.
NOTE
• For best wash performance, clean the filter after
each load. If food debris remains in the filter, it
may cause an odor.
• In areas with hard water, clean the filter at least
once a month with a soft brush.
• Clean the filters using non-abrasive materials
and warm running water.
1 Remove the lower rack and position the
bottom spray arm so a wider vee is open to
the front.
2 Turn the inner filter counter-clockwise and
take out the assembled inner filter and
stainless steel filter.
With the filters removed, check the sump
opening and remove any foreign materials, if
needed.
3 Clean the filters with a soft brush under
running water. Reassemble the filters before
reinstalling them.
4 To replace the assembled filters, position the
spray arm so the wider vee is toward the
front. Fit the filters back into the filter holder
and secure them by turning the inner filter
clockwise until it clicks into place.