Owner's Manual

Table Of Contents

Chapter 1 Before use

1-10

⑦ Connect the SATA cable to the hard disk.

⑧

Connect the SATA cable to the SATA port of the main

board.

⑨

Close the cover of the main unit.

⑩

Tighten the screws.

⑪

After installing the hard disk, you must format the

hard disk from the setting menu.

- The first SATA cable port on the main board must be connected at all times. If a

hard disk is not connected, this device may not operate normally.

B. Hard disk replacement

First turn of the power of the device and then unplug the power.

①

Loosen the screw on the left, right and rear side of the product.

②

Separate the cover of the main unit.

③

After removing all of power/S-ATA cable connected to hard disk, please separate

hard disk bracket from the body

④

Loosen the screws on the left and right side of the bracket holding the hard disk.

⑤

Separate the hard disk from the bracket holding the hard disk.

⑥

In the reverse order of removing the hard disk, assemble the new hard disk.

⑦

After replacing the hard disk, turn on the power of the device.

⑧ Reference

Each SATA cable must be connected to the connecting port precisely.

Do not vertically put the hard disk in upright position or put other objects on top

of the hard disk

When connecting/disconnecting the hard disk, do not use a motored tool.

Refer to the following when adding/replacing the hard disk.