Owner's Manual

30 Connections and settings
Event Settings
Sensor
• InputChannel:SelectthenumberoftheALARM-IN
terminal.
• SensorType:ThesensorstatecanbesettoeitherN.O.
(Normally Open) or N.C. (Normally Closed).
• Camera:Selecttheconnectedcamerachanneltothe
ALARM-IN terminal.
• RelayOutput:
- ON:Outputsthealarm(relay)signalviatheALARM-
OUT terminal.
- OFF:Notused.
Motion
• Channel:Selectthechanneltosetmotiondetection.
• Sensitivity:Setthelevelofsensitivityforthecreated
motion detection area. Sensitivity can be set from level
01 to 10 or NONE.
• RelayOutput:
- ON:Outputsthealarm(relay)signalviatheALARM-
OUT terminal.
- OFF:Notused.
Notes:
• In the condition that illumination is low and the
outline of object is not clear enough to see, regardless
of sensitivity, Motion Event could be possible not to
happen. You must check Motion Event before setting.
• Motion area setting
1. Select the desired channel in live screen mode.
2. Press OSD or click the right mouse button to display
the sub-setup menu.
3. Select [Motion] option and press ENTER.
4. Select the desired motion detection area on the
selected channel window screen.
• Using the Remote control
- a/d/w/s:Movethecellboxtoanother
cell zone.
- ENTER:Selectsorcancelsthemotiondetec-
tion area at the current cell position.
• Using the Mouse
- Toselectthearea:Drag&dropacelltothe
right to select the motion detection area.
- Tocancelarea:Drag&dropacellpointof
a selected cell area to the left to cancel the
motion detection area.