Owner's Manual

Connections and settings 15
HDD INSTALLATION
Note for Hard Disk Drive
The internal hard disk drive (HDD) is a fragile piece of
equipment. Please follow the guidelines below when using
the DVR to protect against possible HDD failure.
We recommend that you back up your important record-
ings onto an external backup device in order to prevent
accidental loss.
Make sure that the power is turned OFF when attaching or
removing the HDD.
Do not move the DVR while the power is on.
Do not use the DVR in excessively hot or humid places,
or in places that may be subject to sudden changes in
temperature. Sudden changes in temperature can cause
condensation to form inside the DVR. This can be a
cause of HDD failure.
While the DVR is switched on, do not unplug from the
wall socket or switch the electricity off from the breaker
switch.
If there’s a power failure while the DVR is on there is a
chance that some data on the HDD will be lost.
Do not drop the HDD. Also do not put the metallic
object such as coins or screwdrivers into the HDD tray.
When a power failure occurs during recording, avoid
adding, replacing or transporting the HDD as the
recorded data may be erased. In this case, turn the
power back on to boot up the unit normally with the
HDD that was being used at the time of the power fail-
ure attached. Then add, replace, or transport the HDD.
The HDD is very delicate. Handle the HDD with care
and follow the precautions below because even a small
shock may damage the internal components of the
HDD.
Do not place the HDD on a desk or a table directly.
Put a thick cushion under the HDD because even a
small shock may damage the internal components
of the HDD.
Do not use an electric screwdriver. Vibrations and
shocks caused by an electric screwdriver may dam-
age the internal components of the HDD.
When replacing the HDD, do not knock the HDD
with other components such as another HDD and
the HDD tray.
Do not knock the HDD with tools such as a driver
when replacing the HDD.
Protect the hard disk drives from static electricity.
•
•
•
•
•
•
•
-
-
-
-
•
Installing or Replacing the Hard
Disk Drive
Installing the Hard Disk Drive
You can install up to 2 HDDs. (LE2104 model only)
However, since the product contains many parts which may
incur electric shocks, accidents or product breakdown, and
because improper installation or setup may disturb HDD
recognition or normal product operation, you should con-
sult with an expert from the store where the product was
purchased.
Turn the power of the unit off and detach the power
plug from the outlet.
1.
Remove the fixing screws on the left/right side and rear
panel.
2. Detach the top case by sliding it after removing the
screws.
3.
Detach the front panel.
4. Remove the screws and detach the hard disk mounting
brackets from the unit.
In case of LE2104 model
In case of LE2104D model
•
•