Owner's Manual

30 Connections and settings
Event Settings
Sensor
Input Channel: Select the number of the ALARM-IN
terminal.
Sensor Type: The sensor state can be set to either N.O.
(Normally Open) or N.C. (Normally Closed).
Camera: Select the connected camera channel to the
ALARM-IN terminal.
Relay Output:
ON: Outputs the alarm (relay) signal via the ALARM-
OUT terminal.
OFF: Not used.
•
•
•
•
-
-
Motion
Channel: Select the channel to set motion detection.
Sensitivity: Set the level of sensitivity for the created
motion detection area. Sensitivity can be set from level
01 to 10 or NONE.
Relay Output:
ON: Outputs the alarm (relay) signal via the ALARM-
OUT terminal.
OFF: Not used.
Notes:
In the condition that illumination is low and the outline
of object is not clear enough to see, regardless of sen-
sitivity, Motion Event could be possible not to happen.
You must check Motion Event before setting.
Motion area setting
1. S
elect the desired channel in live screen mode.
2. Press OSD or click the right mouse button to display
the sub-setup menu.
3. S
elect [Motion] option and press ENTER.
4. Select the desired motion detection area on the
selected channel window screen.
Using the Remote control
b / B / v / V: Move the cell box to anoth-
er cell zone.
ENTER: Selects or cancels the motion detec-
tion area at the current cell position.
Using the Mouse
To select the area: Drag & drop a cell to the
right to select the motion detection area.
To cancel area: Drag & drop a cell point of
a selected cell area to the left to cancel the
motion detection area.
•
•
•
-
-
•
•
•
-
-
•
-
-