Owner's Manual

17
Replacing the Hard Disk Drive
Turn the power of the unit off and detach the power
plug from the outlet.
1.
Follow steps 1-3 described in “Installing the Hard
Disk Drive”.
2.
Remove the connector from the HDD.
3. Remove the screws from the hard disk drive on
the left/right side of the hard disk the mounting
bracket.
4. Remove the HDD from the hard disk mounting
bracket.
5.
Install the new HDD in the reverse order to when
replacing the hard disk drive.
6.
After replacing the hard disk drive, insert the
power plug into the outlet and turn the power of
the unit on.
Notes:
•
Make sure that each of the SATA cables is con-
nected to the connector housing through its holes.
•
Do not stack them nor keep them upright.
• Do not use an electric screwdriver to fix them.
Recommended HDD
The following HDD has been tested and compatibility
is ensured. When you attach multiple HDDs use the
recommended HDDs.
Note:
If you do not use the recommended HDD, the system
may not be operated normally.
Maker RPM Capacity Interface Model No.
Seagate
7,200 250 GB SATA ST3250311SV
7,200 500 GB SATA ST3500410SV
5,400 1 TB SATA ST31000424CS
Hitachi 5,700 1 TB SATA HCS5C1010CLA382
HOOKUP AND
SETTINGS