Owner's Manual

32
Spot Monitor
l Dwell Time: You can set the channel sequence
time to 2 SEC, 5 SEC, 10 SEC, 20 SEC, 30 SEC,
40 SEC, 50 SEC, 60 SEC, 70 SEC, 80 SEC or 90
SEC.
l Event Popup: Displays an event popup on the
spot monitor if motion, sensor or all (motion or sen-
sor) occur.
l Covert Camera:
- ON: If you set to ON, the covert channel(s)
is(are) not displayed on the spot monitor .
-
OFF: The covert channel(s) is(are) not displayed
on the spot monitor with power and normal
user. View the all channels with Administrator
user.
Event Settings
Sensor
l In: Displays the number of the ALARM-IN terminal.
l Sensor Type: The sensor state can be set to
either N.O. (Normally Open) or N.C. (Normally
Closed).
l Camera: Select the connected camera channel to
the ALARM-IN terminal.
l Relay Output: Select the alarm (relay) output
number for the RELAY-OUT terminal for the output
alarm (relay) signal.
l Preset: Select the preset number. When the input
is activated, the camera moves to the selected pre-
set position and the picture of the camera in that
position appears on the monitor.
Motion
l Channel: Select the channel to set motion detec-
tion.
l Sensitivity: Set the level of sensitivity for the cre-
ated motion detection area. Sensitivity can be set
from level 01 to 10 or OFF.
l Relay Output: Select the number of the RELAY-
OUT terminal for the output alarm (relay) signal
when motion is detected.
l Area: Select the desired motion detection area on
the preview window screen.
- b / B / v / V: Moves the yellow cell box to
another cell zone.
-
ENTER: Selects or cancels the motion
detection area at the current cell position.
-
Press ESC to exit the settings.
Notes:
•
You can select the motion detection area by using
the mouse.
-
To select the area: Drag & drop a cell to the
right to select the motion detection area.
-
To cancel area: Drag & drop a cell point of
a selected cell area to the left to cancel the
motion detection area.
•
In the condition that illumination is low and the
outline of object is not clear enough to see,
regardless of sensitivity, Motion Event could be
possible not to happen. You must check Motion
Event before setting.