Owner’s Manual
Table Of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- PRODUCT OVERVIEW
- INSTALLATION
- Before Installing
- Choosing the Proper Location
- Removing/Assembling Handles
- Removing/Assembling Doors and Drawers
- Removing the Hinge Cover
- Removing the Left Refrigerator Door
- Removing the Right Refrigerator Door
- Removing the Freezer Drawer
- Removing the Full-Convert Drawer
- Assembling the Freezer Drawer
- Assembling the Full-Convert Drawer
- Assembling the Right Refrigerator Door
- Assembling the Left Refrigerator Door
- Assembling the Hinge Cover
- Connecting Refrigerator to Water Supply
- Leveling and Door Alignment
- Turning on the Power
- OPERATION
- SMART FUNCTIONS
- MAINTENANCE
- TROUBLESHOOTING
- LIMITED WARRANTY
18 INSTALLATION
Assembling the Full-Convert
Drawer
1 Grasp the door on each side and lower it into
place on the rails.
2 Pull the drawer open to full extension. Lower
the basket onto the rails.
Assembling the Right Refrigerator
Door
CAUTION
• Install the right-side door first.
1 Make sure that the plastic sleeve is inserted in
the bottom of the door. Lower the door onto
the middle hinge pin as shown in the figure.
2 Fit the hinge a over the hinge lever latch b
and slot it into place. Rotate the lever c
counterclockwise to secure the hinge.
3 Connect all the wire harnesses d. Screw in
the ground wire
e.
NOTE
• The number of wire harnesses may vary
depending on the model.
• Ground wire is only present on some models.
Assembling the Left Refrigerator
Door
CAUTION
• Install the left refrigerator door after the right
door is installed.
1 Make sure that the plastic sleeve is inserted in
the bottom of the door. Install the refrigerator
door onto the middle hinge.