Owner’s Manual
Table Of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- PRODUCT OVERVIEW
- INSTALLATION
- Before Installing
- Choosing the Proper Location
- Removing/Assembling Handles
- Removing/Assembling Doors and Drawers
- Removing the Hinge Cover
- Removing the Left Refrigerator Door
- Removing the Right Refrigerator Door
- Removing the Freezer Drawer
- Removing the Full-Convert Drawer
- Assembling the Freezer Drawer
- Assembling the Full-Convert Drawer
- Assembling the Right Refrigerator Door
- Assembling the Left Refrigerator Door
- Assembling the Hinge Cover
- Connecting Refrigerator to Water Supply
- Leveling and Door Alignment
- Turning on the Power
- OPERATION
- SMART FUNCTIONS
- MAINTENANCE
- TROUBLESHOOTING
- LIMITED WARRANTY
23INSTALLATION
ENGLISH
• Do not insert the snap ring on the hinge of the
outer door section.
NOTE
• The number of freezer drawers may vary
depending on the model.
Turning on the Power
• After installing, plug the refrigerator’s power
cord into a 3-prong grounded outlet and push
the refrigerator into the final position.
CAUTION
• Connect to a rated power outlet.
• Have a certified electrician check the wall outlet
and wiring for proper grounding.
• Do not damage or cut off the ground terminal of
the power plug.
Position the Refrigerator
• If the refrigerator is connected to water, arrange
the coil of tubing so that it does not vibrate
against the back of the refrigerator or against
the wall. Push the refrigerator back toward the
wall, leaving adequate clearance.
Start the Icemaker
• If the water line is connected, set the icemaker
power switch to the ON position.
• The icemaker will not begin to operate until it
reaches its operating temperature of 15 °F (–9
°C) or below. It will then begin operation
automatically if the icemaker power switch is in
the ON (I) position.