Owner's Manual

21
7.2 Use of the gas oven
7.2.1 Electronic spark lighting
Open the oven door completely, press the
thermostat knob and turn it clockwise to max.
temperature. The electronic spark lighting device
will be enabled automatically. Once the oven is lit,
hold the knob down for a few seconds to allow the
thermocouple to heat up.
This device should not be enabled for more than 15 seconds; if after
this time the burner has not come on, stop, fully open the oven door
and try again after one minute.
7.2.2 Manual lighting
Open the oven door completely and turn the
thermostat knob. Place a lit match to the
mouth of the flame pipe A in the centre of the
oven floor and press the thermostat knob.
Once the oven is lit, hold the knob down for a
few seconds to allow the thermocouple to
heat up and check that the oven is lit through the inspection hole B.
Choose the cooking temperature by turning the knob clockwise to
the desired temperature, between 50° and 275°C.
If the burner is accidentally switched off, turn the knob to the off
position () and wait for one minute before lighting again.
150
MIN
175
200
225
250
275
150
MIN
175
200
225
250
275