Owner's Manual

Instructions for the installer

2. For LPG turn the by-pass screw clockwise as far as it will go.

For natural gas, regulate the by-pass so that turning the thermostat

knob from minimum to maximum the flame remains stable and

constant. Once the regulation has been completed, replace the seal

on the by-pass using paint or similar materials. Close the oven door

and make sure that the burner stays on minimum.

4.4 Regulation of the grill burner minimum level)

The grill burner tap is equipped with a by-pass to regulate the

minimum level, which is visible at the side of the tap rod.

When the gas type is changed, the by-pass should be regulated as

follows:

1. Turn on the grill burner to maximum for 10/15 minutes with the

door closed.

Turn the knob to the minimum temperature, remove the knob and

regulate using a flat screwdriver.

2. For LPG turn the by-pass screw clockwise as far as it will go. The

by-pass diameter is shown in the paragraph “3.2 / 3.3 Burner and

nozzle characteristics table”.

3. For natural gas, regulate the by-pass so that turning the knob

from minimum to maximum the flame remains stable and

constant. Once the regulation has been completed, replace the

seal on the by-pass using paint or similar materials. Close the

oven door and make sure that the burner stays on minimum.

4.5 Positioning and levelling of the appliance (Depending on models)

Having carried out the electricity and gas hook-up, level the

appliance using the four adjustable legs. For best cooking the

appliance must be perfectly level.

Depending on the model you have purchased, the foot height

adjustment range may vary from 70 to 95 mm and from 110 to 160

mm. These heights refer to the distance between the highest point

of the foot (fixed part) and the lowest point (movable part which

rests on the floor).