Owner's Manual

9
Installation and Setup
Speaker System Connection
Connect the speaker cords to the speaker terminals.
To obtain the best possible surround sound, adjust the
speaker parameters (volume, distance, etc.).
Notes:

Be sure to match the speaker cable to the
appropriate terminal on the components: + to + and
– to –. If the cables are reversed, the sound will be
distorted and will lack base.

If you use front speakers with low maximum input
rating, adjust the volume carefully to avoid
excessive output on the speakers.
About Ferrite Core (Optional)
Be sure to attach the ferrite core to the speaker
cables (for connecting to this unit).
This ferrite core can reduce noises.
How to attach the ferrite core
1. Press the stopper [a] of the ferrite core to open.
2. Wind the cable once on the ferrite core.
3. Close the ferrite core unitl it clicks.
Note:
Attach the ferrite core near the unit (Refer to the fig.3 and
comment.).
1
2
3
The length here is
short as much as
possible.
80 mm