Owner's Manual

Preparation
9
Connections
(Continued)
Speaker System
Connection
ote
If there is a
strong electromagnetic
wave
product
nearby,
an interference
may
be occured.
(Ex
: Micro wave
oven)
Wireless
TX
LED
indicator
of
Wireless
TX
*
LED indicator
-
"BLUE"
The main set is turned
on,
the Wireless TX is connect-
ed the SOUND SIGNAL connector and rear
(right, left)
speaker
connectors with the sound
signal
cable and is
connected the DC IN connector at the Wireless TX
and the Wireless TX
(DC
7V
OUT)
connector at the
main set with the DC
power
cable.
*
LED indicator
-
"OFF
(No display)"
The main set is turned off.
Wireless
RX
LED
indicator
of
Wireless
RX
*
LED indicator
-
"BLUE"
The Wireless TX is
receiving
a
signal
of Wireless TX.
*
LED indicator
-
"RED"
The Wireless RX is in
standby
mode.
Changing
a channel of Wireless
TX
and Wireless
RX
If there is a similar wireless
product nearby,
interference
may
occur. In this
case,
change
to other channel
using
ID/CHNNEL
(ID./CH.)
button of Wireless TX.
Press the
ID/CHNNEL
(ID./CH.)
button
for
less than
about
3
seconds.
ote
The Wireless RX
may
not receiced the
changed
channel of
Wireless TX. In this case
press
the ID button
(or
ID./CH
button)
of Wireless RX for less than about 3 seconds.
-
The Wireless RX searches the
changed
channel.
Setting
a
ID
of Wireless
TX
and
Wireless
RX
When the unit is
manufactured,
ID are
already
set.
If an interference is occured or
you
use a new Wireless
RX,
set the new ID.
1. Set the distance between the Wireless TX and the
Wireless RX within 50cm.
2. Turn the Wireless TX and Wireless RX on.
3. Press the ID/CHNNEL
(ID./CH.)
button of Wireless
TX and ID button of Wireless RX at the same time
for more than about 3 seconds.
otes
If there is a
strong electromagnetic
wave
product nearby,
an
interference
may
be occured.
Do not
operate
a
portable
transmitter
(such
as a wireless
network
device)
near this
product.
LED
indicator
Displays
the
operated
status.
SIGNAL ID./CH. DC IN
SOUND SIGNAL
connector
ID/CHNNEL
(ID./CH.)
button
DC IN connector
LED
indicator
Displays
the
operated
status.
ID. button
(or
ID./CH.
button)
STANDBY/ON button
(If you press
this
button,
Power
is off and If
you press
this
button once
more,
it is in
standby mode.)
Wireless
speaker
connector
Power cord