User guide

www.lg.com
ENGLISH
SIMPLE MANUAL
DVD Home
Theater
System
To view the instructions of advanced features,
visit http://www.lg.com and then download Owner’s Manual.
Some of the content in this manual may differ from your unit.
MODEL
LHD457
*MFL69573603*
Specication
Power
requirements
Refer to main label.
Power
consumption
Refer to main label.
Networked standby : 0.5 W
(If all network ports are
activated.)
Dimensions
(W x H x D)
Approx. 360 mm x 58 mm x
293 mm
Net Weight Approx. 2.3 kg
Bus Power Supply
(USB)
5 V
0
500 mA
Amplier
(Total RMS output
power)
330 W
Design and specications are subject to change without
notice.
How to disconnect the wireless network
connection or the wireless device
Turn off the unit by pressing the power button for more
than 5 seconds.
Replacement of battery
About Ferrite Core (Optional)
Wind HDMI cable around the ferrite core.
POWER: This unit operates on a mains supply of
200 - 240 V ~, 50 / 60 Hz.
Wiring: This unit is supplied with a BS 1363 approved main plug.
When replacing the fuse, always use of the same rating approved
to BS 1362. Never use this plug with the fuse cover omitted. To
obtain a replacement fuse cover contact your dealer. If the type of
plug supplied is not suitable for the mains sockets in your home,
then the plug should be removed and a suitable type tted. Please
refer to the wiring instructions below:
Warning: A mains plug removed from the mains lead of this unit
must be destroyed. A mains plug with bared wires is hazardous
if inserted in a mains socket. Do not connect either wire to the
earth pin, marked with the letter E or with the earth symbol 6 or
coloured green or green and yellow. If any other plug is tted, use
same rating of fuse in the plug.
Important: The wires in this mains lead are coloured in accordance
with the following codes:
- BLUE: NEUTRAL, BROWN: LIVE - As the colours of the wires in
the mains lead of this unit may not correspond with the coloured
marking identifying the terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black. The wire which
is coloured brown must be connected to the terminal which is
marked with the letter L or coloured red.
Additional Information
LHD457-FC_AKENHLK_SIM_ENG_3603.indd 1-2 2016-09-27  2:41:21