Concealed Duct Installation Manual

20
INSTALLATION
ENGLISH
Control box cover can be separated
from main body
Separate whole cover(when access from
bottom of the product).
Remove screws on the bottom panel and grab
the both panel with two hands and pull down
the whole cover.
After remove the control box cover, insert
cables onto the bush and conduit and then
connect at terminal block.
Indoor power cable
Remote controller cable and
transmission cable between
the indoor unit and the
outdoor unit
Conduit Hole
GN/YL
Power Supply
High Voltage
(208/230 V)
Wired Remote
Controller
Insulation, others
Insulate the joint and tubes completely.
THERMAL INSULATION
All thermal insulation must comply with local
requirement.
INDOOR UNIT
Liquid pipe
Refrigerant pipe and thermal
insulation(Local supply)
Union for gas pipe
Insulation
(Local supply)
Clamp for insulation
(Local supply)
Make sure that there is no clearance here.
Overlap with thermal
insulator for piping.
Thermal insulator for refrigerant pipe
(Local supply)
Thermal insulator for
piping(Local supply)
Hose clip for thermal insulator(Local supply)