KARAOKE VCP OWNER'S MANUAL MODEL: LK58 PAL CH01 Before connecting, operating, or adjusting this product, please read this instruction booklet carefully and completely.
PRECAUTIONS Please read these SAFETY PRECAUTION THIS EQUIPMENT MUST BE DISCONNECTED FROM THE ? Avoid extreme ? Avoid using near a magnetic field. adversely affect the units performance.) Be careful when the surface of the case is wiped with a volatile agent such as benzene, alcohol, thinner, etc. or a chemically processed cloth, the surface finish may deteriorate or its coating may peel.
REMOTE CONTROL You of control almost all the functions of the VCP with the wireless remote control. The Remote Control must have "Line can Sight" to the Remote Sensor The maximum operating on the front of the VCP. It must be within an POWER of 30 either side of centre. degrees RECORD To turn the unit on and off. To start PLAY To angle distance is about 25 feet. recording. FAST FORWARD/CUE playback POWER video cassette.
FRONT VIEW CASSETTE COMPARTMENT FAST FORWARD/CUE Insert To advance the a cassette in the compartment. picture search. tape, or for fast forward (see page 9.) FUNCTION INDICATORS Indicates the status of the this unit. PLAY To REMOTE SENSOR WINDOW playback a video cassette. Receives infrared rays from remote control unit. REWIND/REVIEW To rewind the POWER To turn the unit picture and off. on tape search. or for fast reverse (see page 9.
WK130W REAR VIEW AUDIO OUT JACK; Connect this terminal to the audio input terminal on (Audio System, Monitor, Another VCR). VIDEO OUT JACK; Connect this terminal to the video input terminal on an external unit (Monitor, Another VCR). AUDIO IN JACK; Connect the audio output cable from an external unit (Audio System, Monitor, Another VCR) to this terminal. VIDEO IN JACK; Connect the video output cable from an external unit (Monitor, Another VCR) to this terminal.
INSTALLATION CONNECTION (AERIAL) Aerial Coaxial connector cable (provided) To RF OUT AERIAL PREATION AUDIO IN VIDEO IN CHANNEL 40 VIDEO 32 To AERIAL AUDIO RF. OUT OUT K G AERIAL IN 1 2 Remove the coaxial aerial cable from your TV set. Place this cable into the terminal marked "AERIAL" on the VCP. on your TV set to the RF Output Socket on the VCP with the supplied coaxial Connect the aerial terminal connector cable. 3 Plug TV into the AC outlet.
THE VIDEO CASSETTE LOADING Insert the video cassette with the window side up and the label the middle of the tape slowly. facing you. Press UNLOADING Press the STOP/EJECT button in the STOP mode. The cassette compartment will open and the video cassette will automatically be partially ejected. The cassette may also be ejected without VCP is connected to the wall outlet. When the VCP is not in Make sure engaging POWER ON as long as the use....
NORMAL PLAYBACK BEFORE PLAYBACK A TAPE Check your tape programme system. If your tape programme is PAL(or NTSC) or MESECAM, set the switch to PAL/NTSC P.B, or MESECAM position. system select NOTE POWER RECORD If the TV set will can not hold the NTSC vertical then the synchronization signal, up and down. The above symptom is not VCR malfunction.
PLAYBACK VARIATIONS You enjoy can your (SPECIAL EFFECTS) playback picture VISUAL SEARCH During 1 POWER The REVIEW) (REW or tape will be played back in forward (PAL recorded tape)/5 playback speed. 2 and (CUE modes: playback PLAYBACK mode... Press the desired search button RECORD PLAY in various times Press the PLAY button to (NTSC resume FF) recorded normal once to begin visual search. direction about 7 times or reverse tape) faster than the normal speed playback.
PLAYBACK VARIATIONS (SPECIAL EFFECTS) STILL PLAYBACK 1 (FRAME ADVANCE) Press the STILL/F.ADV button to stop the picture the on screen during play- back. 2 POWER When you press STILL/F.ADV button be played back frame by frame. RECORD 3 During still during still playback mode, press the PLAY button to return to normal playback, the tape will playback. NOTES PLAY The still picture may be unstable or noise bars may appear. still playback mode, press the STILL/F.
RECORDING RECORDING TV/MONITOR Aerial method 1 2 on recording jacks. Connect the VCP to Turn the TV can be TV as a used to only a TV with AUDIO/VIDEO output shown left. and select the programme you wish to record with the TV's channel selector. 3 AUDIO VIDEO (LINE) This Insert a cassette with tab in place, of cellophane The REC indicator will be lit, and the or cover the hole with a piece IN tape.
BEFORE REQUESTING SERVICE Check the following points before calling service a CHECK POINT & CORRECTION SYMPTOM No power... Video cassettes can't be inserted... ? Check that the Power ? Check that the POWER button is set to ON. ? Check that the power cord completely connected to its source. Insert the cassette with the window side up and the safety tab facing you. ? RECORD mode can't be There is engaged... playback picture, or the playback picture has noise bars...
