Owner's Manual

NORMAL PLAYBACK
8
PLAYBACK
BEFORE PLAYBACK
A TAPE
Check
your tape
programme
system.
If
your tape
programme
is
PAL(or NTSC)
or
MESECAM,
set the
system
select
switch to PAL/NTSC
P.B,
or MESECAM
position.
If the TV set can not hold the NTSC vertical
synchronization
signal,
then the
picture
will move
up
and down.
The above
symptom
is not VCR malfunction.
TO START PLAYBACK
1 Turn on the TV and set the video channel on
your
TV,
the same as selected
on video's RF channel control.
2 Insert a
pre-recorded
video
cassette,
the VCP is turned on
automatically
and
playback
starts
automatically.
If the cassette has a
safety
tab,
press
the PLAY
button to start
playback.
3
After
viewing
the
tape, press
the
STOP(or STOP/EJECT)
button to
stop
playback.
Press the STOP/EJECT button to remove the
tape.
TRACKING ADJUSTMENT
AUTO
TRACKING;
When
playback
is
started,
the auto
tracking
function
operates
and
adjusts
automatically
so the
picture
is
optimized.
?
During finding
the
optimum point,
PLAY indicator flickers on the front
panel.
?
After
completing
the
optimum point,
PLAY indicator is settled on the front
panel.
This function will be
operated
in normal
playback
mode.
If
you
use a
poorly
recorded
tape,
the noise level
may
fail to reach the
opti-
mum
point.
In this
case,
perform
MANUAL TRACKING
adjustment
as below.
MANUAL
TRACKING;
Press TRACKING
(
or
)
buttons for best
picture. May
also be used
during searching
to move the noise bars
up
or down on the screen.
AUTOMATIC PLAYBACK
(FULL
AUTO
FUNCTION)
You can
enjoy
the convenient full auto function which is called "AUTO PLAY".
If
you
insert a cassette
tape
without a
safety
tab in
place
into the
VCP,
the video
programme begins
automatically. (Refer
to "FULL AUTO FUNCTION"
diagram.)
NOTES
NOTE
LOAD
TAPE
AUTO
REWIND
AUTO
POWER
OFF
AUTO
EJECT
AUTO
PLAY
FULL AUTO FUNCTION
Tracking
is
automatically
reset to normal when the cassette is inserted or the
power
cord is
plugged
in.
POWER RECORD
PLAY
STOP
TV/VCR A.REPEAT
A.TRK TRK
STILL/F.ADV