CAR CD/MP3/WMA Receiver OWNER'S MANUAL MODEL : LAC-M6600 Please read this instruction booklet before The connecting, operating working life of this product or carefully and completely adjusting this product. is 7 years since the date of purchase.
Safety note CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT SPLIT NO USER SERVICEABLE PARTS INSIDE. COVER(OR BACK) REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The flash with arrowhead lightning is intended to alert the to constitute a an product's enclosure that may be of risk of electric shock to persons.
Safety ? A defective note / Table of contents or soiled disc inserted into unit can cause sound to drop out during playback. ? Handle the disc ? Do not touch the surface of the unlabeled side of the disc. by holding Do not stick paper 8cm or tape its inner and outer etc. on the surface. Do not expose the disc to direct sunlight This unit cannot be 8cm disc ? Clean the disc before with ? operated by a Never cleaning use playback. Wipe or excessive heat.
Before use Detachable front 2 The front 1 2 3 3 4 panel of this unit panel can be detached to prevent theft. Press the (RELEASE) to open the front panel. Push the front panel to right. Pull the front panel. Place the front panel in the supplied protective case.
Front Panel 12 3 4 567 PWR DISP VOL SRC EQ XDSS MUTE BAND 19 18 17 23456 FSCAN RPT SHF 1 16151413 12 F+ AS/PS 11 SEL.
Remote control POWER 3 [PWR] / MUTE [SEL] SOURCE [SRC] 4 PLAY / PAUSE B/X 1 1 2 3 4 10 11 12 5 INTRO SCAN 6 SHUFFLE 7? 5 6 SELECTION 2 ? 13 8 14 9 15 MP3 TRACK +10 MP3 WMA FOLDER UP MP3 WMA [F+] CD SKIP / SEARCH ?m m 8? 7 [SCAN] [SHF] ?SEEK/TUNE?mm 9[ BAND] 10VOLUMEUPU/DOWNu 16 11 NUMBER [#] [RPT] NUMBER [0 -9] 12 REPEAT 13 14?CDSKIP/SEARCHMM? ?SEEK/TUNEMM? 15 DISPLAY 16 [DISP.
Installation Basic Installation Before make installing, OFF and remove sure that the ignition-switch is set battery to avoid the terminal of the to Bend the claws car according short-circuiting. 1 Remove the 2 3 Make the necessary connections. Install the installation sleeve. 4 Install the unit into the installation sleeve. existing to the thickness of the dashboard receiver unit. Front Removing the existing receiver unit.
Connection Before connecting, make sure diagram that the ignition switch is set to OFF, and remove the battery terminal to avoid short circuits. A B PHONE MUTE (ORANGE) GROUND(-) (BLACK) DIMMER (PINK) TO IGNITION DIMMER SWITCH (RED) IGNITION SWITCH TO BATTERY(+) (YELLOW) POWER ANTENNA (BLUE) AMPLLIFIER BATTERY (Optional) REMOTE ON (BLUE/WHITE) POWER ANT CONTROL RELAY C 1. WHITE FL+ 2. WHITE/BLACK STRIPE FL3. GRAY FR+ 4. GRAY/ BLACK STRIPE FR5. GREEN RL+ 6.
Connection A B C From antenna To the wiring Connections Speaker of the vehicle colors of leads. 8 ? BLACK : This lead is for the ground ? ORANGE : This lead is for the phone ? PINK : 7 6 5 4 3 2 1 connection. line connection. This lead is for the dimmer line connection. ? RED : This lead is for connection to the power supply terminal when the ignition switch is L set to ACC. ? YELLOW : FRONT This lead is for connection to the (back-up) terminal always supplied.
Basic Turning operation the unit Press the PWR on (POWER/MUTE on the remote control) or any other button. Note When you insert the CD in the CD Turning Press the slot, the unit turns on. the unit off PWR.(POWER/MUTE Selecting on the remote control for more than 1.2 seconds.) a source Press the SRC repeatedly to select a source. lights up in the following order. Tuner The indicator → CD → Tuner...
Basic Using the EQ (Equalizer) The equalizer lets you adjust the the car's interior design. Press the EQ/XDSS Pop t EQ off Classic t repeatedly. Rock t equalization The indicator Jazz Vocal t to match the acoustic characteristics of lights t Salsa up in the t following Samba t order. User1 t User2 t (No display) Optimized Optimized Optimized for R&B, Soul and Country music.
Radio operation to radio stations Listening Press the SRC to select the radio. 1 Press the BAND 2 repeatedly The indicator lights Seek : to select up in the following a band. order. FM1 t FM2 t FM3 t MW(AM) tuning Press the ?m/M? (?m m/M M? on the remote control). The tuner will scan the frequencies until a broadcast with strong enough reception is 3 found. Manual The tuning : Press the m/M (Press the ?m m/M repeatedly.) repeatedly. down step by step.
CD/MP3/WMA operation The unit Before can play MP3/WMA formatted recordings on CD-ROM, CD-R or CD-RW discs. playing MP3/WMA recordings, read the notes on MP3/WMA Recordings on page 16. This unit memorizes last track from the last disc that is listened. The last track remains in memory even if you remove the disc from the unit or switch off the unit. If you load has the track memorized, the track is automatically recalled.
CD/MP3/WMA operation Random 1 Press the SHF The (The during playback. SHF appears in the display window. current selected folder on the disc is played randomly.) The SHF appears in the display window. (All of the music on the disc is played randomly.) Press and hold the SHF for about 2 seconds during playback. The SHF appears in the display window. (All of the music on the disc is played randomly.) 2 Press the SHF The SHF or again. SHF disappears in the display window.
Troubleshooting Cause Symptom Correction Power doesn't Leads and connectors turn properly on. The unit doesn't are not connected. Confirm once more connections The fuse is blown. Rectify the it. Be very that all correct. that caused problem the fuse to operate. are blow, and then replace sure to install the correct fuse with the Noise and other factors are same Turn the unit off and then rate. on. causing the built-in microprocessor to operate incorrectly.
Specifications MP3/WMA Disc 1. 2. 3. 4. compatibility with this unit is limited as follows: Sampling Frequency / 8 48kHz (MP3) 22.05 48kHz (WMA) Bit rate / within 8 320kbps (include VBR) (MP3) 32 320kbps (WMA) CD-R/CD-RW physical format should be "ISO 9660" If you record MP3/WMA files using software which cannot create a FILE SYSTEM, for example "Direct-CD" etc., it will not be possible to playback MP3/WMA files. We recommend that you use "Easy-CD Creator" which creates an ISO9660 file system.
