Owner's Manual

Troubleshooting
Check
the
following guide
for
the
possible
cause
of a
problem
before
contacting
service.
Symptom
No
power.
No sound.
The unit does not start
playback.
The remote control
does not work
properly.
Cause
?
The
power
cord is disconnected.
?
The audio cables are not connected
securely.
?
The
power
of the external source
equip-
ment is switched off.
?
The
speaker
cable is set
to the
wrong position.
?
No disc or
tape
is inserted.
?
An
unplayable
disc or
tape
is inserted.
?
The disc is
placed upside
down.
?
The disc is not
placed
within the
guide.
?
The disc is
dirty.
?
The remote control is not
pointed
at the
remote sensor of the unit.
?
The remote control is too far from the
unit.
?
There is an obstacle in the
path
of the
remote control and the unit.
?
The batteries in the remote control are
exhausted.
Correction
?
Plug
the
power
cord into the wall outlet
securely.
?
Connect the audio cable into the
jacks
securely.
?T urn on the
equipment
connected with
the audio cable.
?
Set the
speaker
cable to the correct
position,
then turn on the unit
again by
pressing
POWER.
?
Insert a disc disc or
tape.
?
Insert a
playable
disc or
tape.
?
Place the disc with the
playback
side
down.
?
Place the disc on the disc
tray correctly
inside the
guide.
?
Clean the disc.
?
Point the remote control at the remote
sensor of the unit.
?
Operate
the remote control within about
23ft(7m).
?
Remove the obstacle.
?
Replace
the batteries with new ones.
About MP3
?
An MP3 file is audio data
compressed by using
the
MPEG1 audio
layer-3 file-coding
scheme. We call files
that have the
".mp3"
file extension "MP3 files".
?
The unit can not read an MP3 file that has not
".mp3"
file extension.
About
WMA
?
An WMA file is a Microsoft audio
compression
tech-
nology.
?
WMA(Windows
Media
Audio)
offers double the audio
compression
of the MP3 format.
MP3/WMA
Disc
compatibility
with this unit is limited
as follows:
1.
Sampling Frequency
/ 8
-
48kHz
(MP3),
32
-
44.1
kHz
(WMA)
2. Bit rate / 8
-
320kbps (MP3),
32
-
128kbps (WMA)
3. CD-R
physical
format should be "ISO 9660"
4. If
you
record MP3/WMA files
using
the software
which cannot create a FILE
SYSTEM,
for
example
"Direct-CD"
etc.,
it is
impossible
to
playback
MP3
files. We recommend that
you
use
"Easy-CD
Creator",
which creates an ISO9660 file
system.
5. File names should be named
using
30 letters or less
and must
incorporate ".mp3"
or "wma" extension
e.g.
"********.MP3" or "********.WMA".
6.
Donotusespecialletterssuchas"/:*?"<>"etc.
7. Even if the total number of files on the disc have
more than
1000,
it will
only
be shown
up
to 999.
About
MULTI SESSION
-
This function
recognizes
the multi session disc
according
to a disc of CD-ROM
type.
ex)
If there are MP3/WMA files in the first
session,
the
MP3/WMA file in the first session is
only played.
If there are
only
MP3/WMA files in the whole ses-
sion,
all of the MP3/WMA files in the session are
played.
If there is Audio CD in the first
session,
only
the Audio CD in the first session is
played.
Additional Information