Owner's Manual

Audio
Adjustment
Setting
the
voltage
(OPTIONAL)
If
your
set is
equipped
with a
voltage
selector at the
back
side,
be sure to set it to
your
local
power supplied
before
connecting
the AC
power
cord.
Setting
the CLOCK
1
Press
CLOCK.
(If
the clock
requires setting, press
and hold
CLOCK for more than 2
seconds.)
-
The hours
begin
to blink.
2
Select
a 24 hour
cycle
or 12 hour
cycle by
turning
MULTI
JOG..
3
Press
SET
to
confirm
the selected
hour
cycle.
4
Use
MULTI
JOG. to set the correct hours.
5
Press
SET.
6
Use
MULTI
JOG. to set the correct minutes.
7
Press
SET and
the correct time is shown
on
the
display.
8
Press
CLOCK
at
any
time
briefly
to see the
time.
Volume
Adjustment
?Turn VOLUME CONTROL KNOB clockwise to
increase the sound
level,
or counterclockwise to
decrease it.
?
Press VOLUME
( )
to increase the sound
level,
or
press
the VOLUME
( )
to decrease it on the remote
control.
?
Headphone
Socket
Connect a stereo
headphone plug ( 6.3mm)
into the
headphone jack.
The
speakers
are
automatically
disconnected when
you plug
in the
headphones (not supplied).
Sound
Quality Adjustment
?To
activate stereo sound
Select a desired sound mode
by using
EQ
PATT.
button on the remote control or
EQ
button on the
front
panel.
Each time
you press
the button the indication
changes
as follows.
FLAT
t
POP
t
CLASSIC
t
ROCK
r
MUSICAL
T
SALSA
T
JAZZ
T
DRAMA
r
SAMBA
t
USER MODE
t
FLAT
1
When
you
select
USER
MODE,
press
the
ENTER
button
repeatedly.
You can select Three of sound mode.
(BASS,
MIDDLE,
TREBLE)
2
Adjuet
the
level
by turning
MULTI
JOG.
3
Press
ENTER.
Sleep
Function
When the
sleep
timer is
used,
the
power
is
automatically
turned off after the
specified
time has
elapsed.
1
To
specify
the time
delay
before
the
power
is
turned
off,
press
SLEEP.
In the
display
window
you
can see
for about 5 seconds. This means that the
system
turns off
automatically
after 90 minutes.
Each time the button is
pressed
the time interval
before it turns off is reduced
by
10 minutes. i.e.
80...70... etc. Select the desired time to turn off.
2
To check
the
remaining
time until the
power
is
turned
off.
While the
sleep
function is active
press
SLEEP
briefly.
The time
remaining
until it turns off is
displayed
for about 5 seconds.
ote
If
you press
SLEEP while the
sleep
time is
displayed,
the SLEEP time is reset.
To cancel the
sleep
timer mode
If
you
wish to
stop
the
function,
press
the SLEEP button
repeatedly
until SLEEP 10
appears,
and then
press
SLEEP once
again
while SLEEP 10 is
displayed.
(12HR) (24HR)
or