Owner’s Manual

12 OPERATION
• If you want to set or disable the auto restart
function, press and hold the Power Button
a for
6 seconds.
- You hear 2 beeps and the indicator light pulses
4 times.
NOTE
• The product will automatically restart without
the need to press any buttons.
• Upon restart, the fan will initially operate at a
low speed until the compressor starts, 2 1/2 to 3
minutes later. Once the compressor starts, the
fan will resume its previous setting.
Fan Speed and Cooling Capacity
The cooling capacity indicated in the specification
is the value when the fan speed is set to high, and
the capacity will be lower at low or medium fan
speed. High fan speed is recommended when you
wish to cool the room quickly.
Preparing before Operation
Inserting the Batteries into the
Wireless Remote Control
Insert AAA (1.5 V) batteries into the wireless
remote control.
1 Remove the battery cover and insert the new
batteries, making sure that the + and –
terminals of the batteries are oriented
correctly.
2 Reattach the cover by sliding it back into
position.
NOTE
• When the wireless remote control display begins
to fade, replace the AAA (1.5 V) batteries.
• If the system is not going to be used for a long
time, remove the batteries to save their working
life.
• Do not use old and new batteries together.
Installing the Remote Control
Holder
1 Choose a suitable place where its safe and
easy to reach.
2 Fix the firmly to the wall with the supplied
screws.
3 Slide the remote controller inside the holder.
NOTE
• The remote controller should never be exposed
to direct sunlight.
• The signal transmitter and receiver should
always be clean for proper communication. Use
a soft cloth to clean them.
• If other appliances are accidentally affected by
the remote controller, change their position or
consult your serviceman.