Installation Sheet

–
15
–
STEP 6: Attach The Oven To The Wall
Power Cord
Hole
Power Cord
1. Carefully lift microwave oven and hang it on support tabs
(See Figure 28) at the bottom of the mounting
plate.Reaching through upper cabinet, thread
power supply cord through the power supply cord
hole in the bottom of the upper cabinet.
See Figure 30.
2. Rotate the microwave oven upward so the top of
oven is against the bottom of the upper cabinet or cabinet
frame.
3. Then insert a bolt down through each hole in the
upper cabinet bottom.See Figure 31.
Tighten the bolts until the gap between the upper cabinet
and microwave oven is closed.
4. If wall-vented or room-vented installation is used,go to No.
7 on the next page.
Figure 30
Figure 31
w
W ARNING
To avoid risk of personal injury or property damage, you will need two people to
install this microwave oven.
5. Roof venting installation: See Figure 32.
Install ductwork through the vent opening in the
upper cabinet. Complete the venting system through the
roof according to the method needed. See
Prepare The
Venting System
STEP 2.
Use caulking gun to seal the exterior roof opening around
the exhaust cap. See Figure 7 on page 8.
6. Use the power supply cord clamp to bundle the power
supply cord. Install the power supply cord clamp, using a
screw as shown in Figure 33, to inside of the cabinet.
7. Grasp filter screen with one hand holding the ring and the
other hand holding the opposite end. Insert the end of the
filter screen without ring into the opening and slide
towards the side of the microwave oven. Insert ring end of
filter screen into the opening and slide entire screen
towards the center of the microwave until screen is
securely in position. Repeat for other filter screen. See
Figure 34.
8. Plug in the power supply cord.
9. Read your Owner’s Manual, then check the operation of
your microwave oven.
Damper
Figure 32
Power
supply
Cord
Clamp
Figure 33
Figure 34