Installation manual

ManualsBrandsLG ManualsMicrowave Oven2-cu ft Over-The-Range Microwave with Sensor Cooking Controls (Stainless Steel) (Common: 30-in; Actual: 29.87-in)

STEP 6: Attach The Oven To The Wall

1. Carefully lift microwave oven and hang it on support tabs

(See Figure 30) at the bottom of the mounting

plate.Reaching through upper cabinet, thread

power supply cord through the power supply cord

hole in the bottom of the upper cabinet.

See Figure 32.

2. Rotate the microwave oven upward so the top of the

oven is against the bottom of the upper cabinet or cabinet

frame.

3. Then insert a bolt down through each hole in the

upper cabinet bottom.See Figure 33.

Tighten the bolts until the gap between the upper cabinet

and microwave oven is closed.

Figure 32

Figure 33

Power Cord

Hole

To avoid risk of personal injury or property damage, you will need two people to

install this microwave oven.

W ARNI N G

4. Roof venting installation: See Figure 34.

Install ductwork through the vent opening in the

upper cabinet. Use caulking gun to seal the exterior roof

opening around the exhaust cap. See Figure 7 on page 7.

5. Use the power supply cord clamp to bundle the power

supply cord. Install the power supply cord clamp, using a

screw as shown in Figure 35, to the inside of the cabinet.

6. Grasp the filter screen with one hand holding the ring and the

other hand holding the opposite end. Insert the end of the

filter screen without ring into the opening and slide

towards the side of the microwave oven. Insert ring end of

filter screen into the opening and slide entire screen

towards the center of the microwave until screen is

securely in position. Repeat for other filter screen. See

Figure 36.

7. Plug in the power supply cord.

8. Read your Owner’s Manual, then check the operation of

your microwave oven.

Damper

Power

supply

Cord

Clamp

Figure 34

Figure 35

Figure 36

– 15 –