Installation Guide

ManualsBrandsLG ManualsMicrowave Oven2-cu ft Over-The-Range Microwave with Sensor Cooking Controls (Stainless Steel) (Common: 30-in; Actual: 29.87-in)

– 9 –

STEP 3: Prepare The Venting Blower

Your microwave oven is shipped with the blower assembled for roof-venting. You need to adjust the blower if you

want wall-venting or room-venting installation.

• DO NOT PULL OR STRETCH THE BLOWER WIRING! Pulling and stretching the blower wiring could result in

electric shock.

1. Remove any shipping materials and parts from inside the

microwave oven. Set them aside for later use.

2. Cover the counter top or cooktop with a thick, protective

covering to protect it from damage and dirt. See Figure 11.

NOTE: If you have a free-standing range, disconnect

it, move it onto a piece of cardboard or hardboard and

pull it away from the wall, so that you can get closer to

the upper cabinet and back wall for easier measuring

and drilling.

3. Locate the exhaust adaptor, grease filters and hardware packet.

4. At this point, remove any adhesive tape (if there is any), on the

exhaust adaptor, the grease filters and the power supply cord.

ROOF-VENTING INSTALLATION:

This oven is shipped assembled for roof-venting.

1. Insert the tabs on each side of the damper into the holes

at the inside rear of the adaptor.

Attach the exhaust adaptor to the blower plate with the two

tapping screws provided. See Figure 12.

Make sure that the damper swings freely.

A thick, protective

covering

Figure 11

ELECTRIC SHOCK HAZARD! UNPLUG UNIT BEFORE WORKING ON IT.

W ARNING

FIRE HAZARD! CORRECTLY INSTALL THE VENT FAN BEFORE USE .

•

When changing the vent fan position for a rear wall vent or room vent:

1. Properly align the ventilation fan openings and blower plate knockouts.

2. Ventilation fan openings should be completely exposed to the outside.

•

Improper installation can cause problems such as:

1. Inability to assemble blower plate or ventilation motor correctly.

2. Abnormal noise during product operation.

3. Weak ventilation.

4. Product overheating - possibility of product breakdown or fire.

Figure 12

Damper

Exhaust

Adaptor

Back of

Oven

Exhaust

Adaptor

Blower Plate

3. After installation, check the air ventilation path. Refer to page 7 Figures 6-8 for proper vent selection.

NOTE: Set the product down on a flat surface only.

•

Do not remove the packing tape on the slide-out vent.