User guide

Part Names and Functions
POWER IN
DC - 12 V
a
b
c
d
e
g
h
i
f
a ETHERNET
Connects to a PC or a network via a hub with a 10 BASE-T/100 BASE-TX cable attached RJ-45
connector.
b Power input terminal
Connects to a DC 12 V power supply using proper cables. This camera must always be operated
a DC 12 V. Certied/Listed Adaptor which comply with LPS.
c Pan adjuster
Adjust the pan position.
d Tilt adjuster
Adjust the tilt position.
e Angle adjuster
Adjust the camera angle.
f Lens Cover
g RESET button
Push the button more than 3 seconds, this would restore the factory default network related
settings.
h IR LED
i IR Sensor
Installation
Mounting the camera
Follow the instructions below to ceiling or wall mount the camera.
1. Use the installation guide template to check the mounting location. Face the front of the label
toward the area of interest. Using the template as a guide, make a hole through the ceiling.
2. Connect the cables to the cable jacks of the camera body.
CABLE
3. Install the camera by using M4 Tapping screws to x it on the ceiling.
CABLE
Connecting Waterproof processing of cable
Surely use the Butyl tape.
1. Connect the cables.
2. Bind the cables together with Butyl tape.
• The cables are not waterproofed completely. So seal the tube ends and the portions
between cable cores as well as connecting portions with Butyl tape.
• If not using the Butyl tape, it may cause water absorption from a gap and nally
condensation and water leakage.
,
Adjust the camera position
You should adjust the camera angle position as shown below illustration. Adjust the camera angle
position by following step a and b.
1. Adjust the Pan.
CABLE
2. Adjust the Tilt.
CABLE
3. Adjust the Angle.
CABLE
• Camera can be damaged if you adjust the Pan / Tilt / Angle when the screw is
xed.
• Be careful not to rotate the Pan and Angle more than 360°, it may damage the internal
cable.
,
Connection
Precautions
• Be sure to switch o the unit before installation and
connection.
• The installation should be made by qualied service
personnel or system installers.
• Do not expose the power and connection cables to moisture,
which may cause damage to the unit.
Connecting Network
You can control and monitor the system via network. With the
remote control (monitoring), you can change the system
conguration or monitor the image via network. After the
installation, check the network settings for the remote control
and monitoring work.
Connect the IP camera to your network using a standard RJ-45
network cable as shown below.
Broadband
Service
Broadband
Service
Ethernet device
(IEEE802.3af )
Router
Connecting Power Source
Connect a DC 12 V power source to the power input terminal as
shown below.
(Recommended power adapter is DC 12 V / 1.5 A or above)
ETHERNET
With PoE
ETHERNET
With PoE
When the connecting power adapter, tighten the screws
as shown above.
,